HOW to USE Your Pressure

Provide proper water supply (not 1:oexceed 100°F).

5.Be sure 1:oread =Safety Rules" and ::Opera1:ion" sections before using pressure washer.

,If s1:arting unit after s1:orage, see ::S1:orage"section on page 15.

WASHER

If you have any problems operating your pressure

washer, please call the pressure washer helpline at 1-800-222-3136.

To Start Your Pressure Washer

To el:art your engine-powered pressure washer for the first time, follow these instructions step-by-step. This s1:arting information also applies whenever you start the engine after you have let the pressure washer sit idle for at leas: a day.

1.Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3.0 gallons per minute and no less than 20 PSI at pressure washer end of garden hose.

2, Check that high pressure hose is tightly connected

1:ospray gun and pump. See "Assembling Your Pressure Washer" for illus1:ra1:ions.

,Make sure unit is in a level position.

4.Connect garden hose to wa1:erinlet on pressure washer pump. Turn ON water.

CAUTION

5.Squeeze trigger on gun to purge pump system of air and impurities.

6.Attach nozzle extension to spray gun. Tighten by hand.

7, Position nozzle in low pressure mode (slide nozzle forward) and squeeze trigger on spray gun to relieve pressure caused by turning ON wa1:er. Water will flow out of gun in a thin stream. Continue to hold trigger until there is a s1:eady stream of water and no air remains in system. Release trigger.

8.Engage safety latch 1:ospray gun trigger.

,Move throttle lever to =Fast" position, shown here as a rabbit.

FastStop

Threttle

Leverin

STOP position

NOTE: For a warm engine, be sure the throttle lever is in the =Fast" position.

To start the engine for the very first time:

10.Make sure throttle lever is in ::Fast" position (indice1:edon the engine as a rabbit).

11.Push primer bulb firmly 5 times, waiting 2 seconds between each push.

To start engine thereafter:

10.Make sure throttle lever is in ::Fast" position (indice1:ed on the engine as a rabbit).

11.Press primer bulb firmly 3 times, waiting

2 seconds between each push. For a warm engine, DO NOT press primer bulb.

12.Grasp s1:arter grip handle and pull slowly until you feel some resistance. Then pull rapidly to start

engine.

13.Return s1:arter grip handle slowly. DO NOT let rope =snap back" against starter.

CAUTION

NOTE: Always _:eep the throttle lever in the =Fast" position when operating the pressure washer.