Pentair NT Standard Series installation manual MiniMax NT Standard Heaters Limited Warranty

Page 32

MiniMax NT Standard Heaters

Limited Warranty

Your MiniMax NT Standard pool heater is another quality product from Pentair Pool Products, Inc. and is backed by the following warranty.

1.The following parts are warranted for 5 years from date of purchase:

The MiniMax NT Standard cabinet and combustion chamber, the main burners and burner manifold, the inlet/outlet header and the return header. This warranty does not cover rusting or corrosion on cabinets or burners that does not affect the heater's operation.

2.The following parts are covered for 2 years from date of purchase:

The automatic flow control valve, all controls, heat exchanger, pilot generator and the pilot assembly.

This warranty only applies to the original purchaser.

3.This warranty shall not apply to any units or parts which have been subject to accident, negligence, alteration, abuse, misapplication or misuse.

The above warranty applies only if the heater is installed and operated in complete compliance with the installation and operation manual provided with each unit. Copies of this manual are available by writing to Pentair Pool Products, Inc., at the address below.

Pentair Pool Products, Inc. assumes no liability except for the repair or replacements of parts as specified above. Ship defective parts or equipment along with serial number and purchase date, transportation prepaid to the address below. Purchaser shall be responsible for freight charges for return of merchandise to purchaser. Some states do not allow exclusion or limitation of incidental or consequential damages so the above may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

HEATER SERIAL NUMBER

(Please Fill In)

Pentair Pool Products, Inc.

1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151

10951 W. Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400

P/N 472032

Rev. A 1-2-02

Image 32
Contents MiniMax NT Standard Series For additional free copies of this manual call 800Table of Contents MiniMax NT Standard Code RequirementsOperation Warranty InformationSafety Rules For Your Safety Read Before Lighting Operation LightingInstallation Instructions SpecificationsInstallation Electrical ELECTRICAL, for MiniMax NT Standard HeatersInstallation Remotes TWO-WIRE or THREE-WIRE Remote HOOK-UPWire Remote Three-wire remote Installation Dual Models HSI ElectronicPlumbing Connections Water ConnectionsPlumbing GAS Connections Installation Indoor Indoor VENTING-General RequirementsSee page 15 for Indoor Vent Adaptors Indoor Vent Adaptors Fits ALL Models Installation IndoorInstallation Outdoor VentilationBasic Operation General DescriptionBasic System Operation Safety Controls AIR Pressure FAN SwitchWater Pressure Switch Typical Water Pressure SwitchOperation of Ignition Module Minimax NT Standard Pentair Temperature Controller GeneralBasic Thermostat Operation Normal Operation no RemoteTemperature & Time Setting Programming To Change the Factory Temperature SettingsTime Setting Time SETTING, cont’d Time Setting ProgrammingMaintenance Instructions MaintenanceEnergy Saving Tips Spring and Fall OperationMaintenance Water Treatment Chemical BalancePool and SPA Water If pH becomes too high over alkaline, it has these effectsTroubleshooting-Normal Operation Sequence of Heater Normal Operation SequenceService CHECKS-IGNITION Module Troubleshooting-Normal Operation of HeaterTroubleshooting & Service Troubleshooting General Heater Short Cycling Rapid On and Off OperationMinimax NT Standard Heater Dual Voltage Description QTY MiniMax NT Standard Heaters Limited Warranty