Operation
■STOPPING ENGINE
1.Release the throttle lever and run the engine for a half minute.
2.Shift the ignition switch to the STOP position.
NOTE
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
■ADJUSTING IDLING SPEED
1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw
NOTE
•Warm up the engine before adjusting the idling speed.
■LINE HEAD USAGE 
WARNING
1.Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
2. Keep the debris guard attached in place at all times when the unit is operated.
TRIMMING GRASS AND WEEDS
•Always remember that the TIP of the line does cutting. You will achieve better results by not crowding the line into the cutting area. Allow the unit to trim at its own pace.
1.Hold the unit so the head is off the ground and is tilted about 20 degrees toward the sweep direction.
2.Use full throttle when cutting.
3.You can avoid thrown debris by sweeping from your left to the right.
4.Use a slow, deliberate action to cut heavy growth. The rate of cutting motion will depend on the material being cut. Heavy growth will require slower action than will light growth.
5.Never swing the unit so hard as you are in danger of losing your balance or control of the unit.
6.Try to control the cutting motion with the hip rather than placing the full workload on the arm and hands.
7.Take precautions to avoid wire, grass and dead, dry,
ADJUSTING THE LINE LENGTH
•Your brushcutters is equipped with a semi- auto type nylon line head that allows the operator to advance the line without stopping the engine. When the line becomes short, lightly tap the head on the ground while running the engine at full throttle.
•Each time the head is bumped, the line advance about 1 inch(25.4 mm). For better effect, tap the head on bear ground or hard soil. Avoid bumping in thick, tall grass as the engine may stall by overload.