Zenoah manual  18 , OPT3 OPT4 For BC3401DL OPT5 OPT6, Bracket Handle, Cutting Method

Optional Blade Usage

OPT3

OPT4

FOR BC3401DL

OPT5

OPT6

IMPORTANT

Change to the debris guard which is suitable for the metal blade. (OPT3)

(1) Bolt	: 3540-24130 x 2 pieces
(2) Spring washer	: 0290-20615 x 2 pieces
(3) Clamp	: 3541-24121
(4) Guard	: 3541-24112
(5) Guard ass’y	: 3541-24001

TIGHTENING TORQUE: 130~174 in-lbs(14.7~19.6 N.m.)

IMPORTANT

Change the loop handle to the J-handle for safe operation. (OPT4)

(1)Bracket : 3532-14102

(2)J-handle : 6367-14200

■STARTING ENGINE

Please refer to P.15 ■ STARTING ENGINE

WARNING

•The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.

■CUTTING METHOD

a)Use the front left side cutting.

b)Guide the blade from your right to left with it tilted slightly to your left. (OPT6)

c)When mowing a wide area, start working from your left end to avoid interference of cut grass.

d)The blade may be seized by weeds if the engine speed is too low, or the blade cuts too deep into weeds. Adjust the engine speed and cutting

18 