7. Operation
OP6
OP7
OP8
NOTE
Once the choke knob has been pulled out, it will not return to the operating position even if you press down on it with your finger. When you wish to return the choke knob to the operating position, pull out the throttle lever instead.
5.While holding the saw unit securely on the ground, pull the starter rope vigorousl y. (OP6)
6.When firing occur, push in the choke knob and pull the starter again to start the engine.
7.Allow the engine to warm up with the throttle lever pulled slightly.
WARNING
Before you start the engine, make sure the saw chain is not contacting anything.
■CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed and see if chain oil is scattered off as shown in the figure. (OP7)
(1) Chain oil
The chain oil flow can be changed by inserting a screwdriver in the hole on bottom of the clutch side. Adjust according to your work conditions. (OP8)
(1)Chain oil flow adjusting shaft
(a) Rich
(b) Lean
NOTE
The oil tank should become nearly empty by the time fuel is used up. Be sure to refill the oil tank every time when refueling the saw.
13