5. Installing guide bar and saw chain
SE1
SE2
SE3
SE4
A standard saw unit package contains the items as shown below. (SE1)
(1)Power unit
(2)Guide bar
(3)Saw chain
(4)Plug wrench
Open the box and install the guide bar and the saw chain on the power unit as follows.
WARNING
The saw chain has very sharp edges. Use protective gloves for safety.
1.Pull the guard towards the front handle to check that the chain brake is not on.
2.Loosen a nut and remove the chain cover.
3.Fix the hanger on the rear of power unit by screw. (SE2)
(1) Hanger
4.Mount the guide bar then fit the saw chain around the bar and sprocket.(SE3)
WARNING
Pay attention to the correct direc-tion of the saw chain
5.Fit the chain tensioner nut into the lower hole of the guide bar, then install the chain cover, and fasten the mounting nut to finger tightness. (SE3)(SE4)
(1)Hole
(2)Moving direction
(3)Chain tensioner nut
WARNING
When installing the chain cover, be sure to fit the hook completely at the rear end of the cover.
8