MA Series Power Amplifiers
5 Advanced Features and Options
For PIP2s featuring ribbon cable connectors, simply locate the two connectors on the under- side of the PIP circuit board, then connect the two input ribbon cables coming from the ampli- fier (see Figure 5.3). Both ribbon cables should run smoothly from the amplifier to the PIP card. Insert the PIP and attached cables into the PIP opening in the back of the amplifier, then screw securely into place.
WARNING: Disconnect power to the amplifier when installing or removing a PIP module.
5.3.2 Cooling Fan Options
Every
5.3.3 Level Control Shaft Lock
A security accessory, the shaft lock can be used to secure your amplifier's level controls in situations where the front panel controls are subject to tamper- ing. One is needed for each channel. They can be ordered through the Crown Service/Parts Depart- ment. For more information, contact your local Crown dealer or Crown Technical Support.
Figure 5.3 Installing a PIP2 Module | Figure 5.4 Installing a Level Control Shaft Lock |
Operation Manual | page 17 |