How To Prepare the Machine For Operation
How To Install The Brush Or Pad Driver
To install the brush or pad driver on the machine, follow this procedure:
1.Turn the main switch "OFF".
2.Put the brush lever in the "UP" position.
3.Go to the front of the machine.
4.Using a short Phillips screw driver, loosen the latch screw enough to allow the retainer to be free of the cover. (See figure 5a, 1)
5.Open the brush motor cover and remove the brush housing. See figures 5a and 5b.
6.Put a brush or pad driver under the brush hous- ing. See figure 5c.
7.Align the lugs on the motor with the slots in the brush gimbal.
8.Pull the brush up and rotate counter clockwise until gimbal locks.
9.Replace brush housing and close brush motor cover.
10.Install the brush retainer latch into the brush motor cover. Tighten the retainer screw.
How To Remove The Brush or Pad Driver
To remove the brush or pad driver from the machine, follow this procedure:
1.Put the brush lever in the "UP" position.
2.Turn the main switch "OFF".
3.Go to the front of the machine.
4.Open the brush motor cover and remove brush housing. See figures
5.Rotate brush clockwise with a quick snapping action until brush releases.
6.Replace brush housing and close brush motor cover.
1
Figure 5a
Figure 5b
Figure 5c
Page | CLARKE TECHNOLOGY Operator's Manual |