OPERATOR SAFETY INSTRUCTIONS
| WARNING | AVERTISSEMENT | ADVERTENCIA | |
|
|
|
| |
| DANGER: | Failure to read and observe all DANGER statements could result in |
| |
|
| |||
|
| severe bodily injury or death. Read and observe all DANGER |
| |
|
| statements found in your Owner's Manual and on your machine. |
| |
| WARNING: | Failure to read and observe all WARNING statements could result in |
| |
|
| injury to you or to other personnel; property damage could occur as |
| |
|
| well. Read and observe all WARNING statements found in your |
| |
|
| Owner's Manual and on your machine. |
|
|
| CAUTION: | Failure to read and observe all CAUTION statements could result in |
| |
|
| damage to the machine or to other property. Read and observe all |
| |
|
| CAUTION statements found in our Owner's Manual and on your |
| |
|
| machine. |
|
|
|
|
|
|
|
|
|
|
|
|
DANGER: Failure to read the Owner's Manual prior to operating or attempting any service or maintenance procedure to your Clarke Technology machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. If you or your operator(s) cannot read English, have this manual explained fully before attempting to operate this machine.
DANGER: Operating a machine that is not completely or fully assembled could result in injury or property damage. Do not operate this machine until it is completely assembled. Inspect the machine carefully before operation.
DANGER: Machines can cause an explosion when operated near flammable materials and vapors. Do not use this machine with or near fuels, grain dust, solvents, thinners, or other flammable materials. This machine is not suitable for picking up hazard- ous dust.
DANGER: Using a machine with a damaged power cord could result in an electrocution. Do not use the machine if the power cord is damaged. Do not use the electrical cord to move the machine.
DANGER: Electrocution could occur if maintenance and repairs are performed on a unit that is not disconnected from the power source. Disconnect the power supply before attempting any maintenance or service.
DANGER: Electrocution or fire could occur if the machine is used on a power circuit that repeatedly trips or is undersized. Have a licensed electrician check the fuse, circuit breaker or power supply, and/or contact your local Clarke Technology distributor for assistance.
WARNING: Operating this machine from anywhere other than the back of the machine could result in injury or damage. Operate this machine only from the rear.
WARNING: This machine is heavy. Get assistance before attempting to transport or move it. Use two able persons to move the machine on a ramp or incline. Always move slowly. Do not turn the machine on a ramp. If operating machine on a gradient over 2%, do not stop, turn or park. Read the "Procedures For Transporting" in this manual before trans- porting as machine might topple over if not strapped..
WARNING: Machines can topple over if guided over the edges of stairs or loading docks and cause injury or damage. Stop and leave this machine only on a level surface. When you stop the machine, put all switches into their "OFF" position.
CLARKE TECHNOLOGY Operator's Manual | Page |