Clarke S20E manual How To Operate The Machine

Page 11
How To Operate The Machine

How To Operate The Machine

How To Operate The Squeegee

The squeegee wipes the floor while the vacuum motor removes the dirty solution form the floor. Use your right hand to lower or raise the squeegee handle. To operate the squeegee, follow this procedure:

1.To lower the squeegee and start the vac motor, move the squeegee lever to the right and down. See figure 6.

2.To raise the squeegee, lift the squeegee lever up. See figure 7.

NOTE: The center position lets the vac motor con- tinue to run with the squeegee off the floor to avoid drips and also allows you to back up the machine.

How To Fill The Solution Tank

The solution tank lid is at the front. To fill the solution tank follow this procedure:

1.Raise the solution tank lid.

2.Add a cleaning chemical to the solution tank. For the correct amount of chemical, follow the directions shown on the container.

3.Fill the solution tank with water.

4.Lower the solution tank lid.

Manual background WARNING: Water solutions or cleaning materi- als used with this type of machine can leave wet areas on the floor surface. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning.

Manual background WARNING: Machines can ignite flammable materials and vapors. Do not use with or near flammables such as gasoline, grain dust, solvents and thinners. Only use a cleaning concentrate recommended by the chemical manufacturer.

Figure 6

Figure 7

CLARKE TECHNOLOGY Operator's Manual -Encore S20E

Page -11-

Image 11
Contents Operators Manual READ THIS BOOKENCORE S20E Table of Contents OPERATOR SAFETY INSTRUCTIONS AVERTISSEMENTADVERTENCIA WARNING: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs must be performed by authorized Clarke Technology personnel only SPECIFICATIONS Introduction & Machine SpecificationsIntroduction & Machine Specifications Procedures For Transporting How to Remove the Machine From a Van or Truck Procedures For Transpoting contMachine Control Panel DD E A BC FG FigureFigure Figure 4a Figure 4b Machine Controls and FeaturesFigure Figure 5a Figure 5b Figure 5c How To Prepare the Machine For OperationHow To Install The Brush Or Pad Driver How To Remove The Brush or Pad DriverHow To Operate The Machine Figure How To Clean A FloorHow To Clean A Very Dirty Floor Operating The MachineSection Parts and Service ManualENCORE S20EACTION HOW TO CORRECT PROBLEMS IN THE MACHINEPROBLEM CAUSEACTION PROBLEMCAUSE MAINTENANCE MAINTENANCE Figure Figure Figure Figure Do These Procedures When You End Your WorkFigure Figure 7 Figure Figure88 Maintenance For The SqueegeeHow To Adjust The Squeegee Adjusting Squeegee PressureFigure Figure How To Adjust The Squeegee contFigure 230 Volt AccessoriesAccessories 115 VoltSERVICE FACILITIES U. S. A. LocationsEuropean Locations Customer Service - Technical Service -CLARKE TECHNOLOGY CLARKE TECHNOLOGY U.S. WARRANTYEIGHT YEAR U.S. GUARANTEE CLARKE TECHNOLOGY POLYDUR TANK