Clarke S20E manual Maintenance

Page 16
MAINTENANCE

MAINTENANCE

DANGER: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Mainte- nance and repairs must be done by authorized Clarke Technology per- sonnel only.

DANGER: Operating a machine that is not completely or fully assembled could result in injury or property damage. Do not operate this ma- chine until it is completely as- sembled. Inspect the machine care- fully before operation. Keep all fas- teners tight.

DANGER: Electrocution could occur if mainte- nance and repairs are performed on a unit that is not properly discon- nected form the power source. Al- ways disconnect the power supply before attempting any maintenance or service.

WARNING: Severe injury could occur to your hands if maintenance or repairs are performed when the machine is on or plugged into power supply. Al- ways turn off power and disconnect machine before attempting any maintenance.

WARNING: SEVERE bodily injury could occur if operator leans body under the tank support to perform maintenance. Always position the tank support all the way over and rest it on the floor before attempting any service and/ or maintenance.

WARNING: Moving parts can cause injury to feet and hands. Keep feet and hands clear from under the machine.

WARNING: Attempting maintenance and or re- pairs to this machine before empty- ing the solution or recovery tank could result in machine or property damage.

WARNING: Keep all fasteners tight.

Page -16-

CLARKE TECHNOLOGY Operator's Manual -Encore S20E

Image 16
Contents ENCORE S20E READ THIS BOOKOperators Manual Table of Contents ADVERTENCIA AVERTISSEMENTOPERATOR SAFETY INSTRUCTIONS WARNING: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs must be performed by authorized Clarke Technology personnel only Introduction & Machine Specifications Introduction & Machine SpecificationsSPECIFICATIONS Procedures For Transporting Procedures For Transpoting cont How to Remove the Machine From a Van or TruckDD E A BC FG Figure Machine Control PanelFigure Machine Controls and FeaturesFigure Figure 4a Figure 4b How To Prepare the Machine For Operation How To Install The Brush Or Pad DriverHow To Remove The Brush or Pad Driver Figure 5a Figure 5b Figure 5cHow To Operate The Machine How To Clean A Floor How To Clean A Very Dirty FloorOperating The Machine FigureParts and Service Manual ENCORES20E SectionHOW TO CORRECT PROBLEMS IN THE MACHINE PROBLEMCAUSE ACTIONCAUSE PROBLEMACTION MAINTENANCE MAINTENANCE Do These Procedures When You End Your Work Figure Figure Figure FigureMaintenance For The Squeegee How To Adjust The SqueegeeAdjusting Squeegee Pressure Figure Figure 7 Figure Figure88Figure How To Adjust The Squeegee contFigure Figure Accessories Accessories115 Volt 230 VoltU. S. A. Locations European LocationsCustomer Service - Technical Service - SERVICE FACILITIESCLARKE TECHNOLOGY U.S. WARRANTY EIGHT YEAR U.S. GUARANTEECLARKE TECHNOLOGY POLYDUR TANK CLARKE TECHNOLOGY