Husqvarna HUV 4213-GXP owner manual Compress Snubber Downward

Page 35

Engine Oil

10.Remove the engine oil filter, turning it counterclockwise, allowing the residual oil in the filter port and filter to drain into the oil drain pan. See following NOTE

NOTE: An oil drip guard can be used to prevent excess oil from dripping into the engine base place. Use an empty quart (one liter) container and cut the bottom off at an angle, then slide the open area of the container up and under the oil filter prior to removing. Position the port of the plastic container so oil will be directed into the oil pan (Figure 20, Page 33). A drip guard can be made by folding a piece of cardboard, thin metal, or plastic under the oil filter forming a channel to direct the filter port oil into the drain pan.

Dispose of used oil according to the environmental laws and regulations for your area.

11.Use a clean, lint-free rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.

12.Install a new oil filter (P/N 603 00 00-06) onto the engine oil filter port. Apply a light coat of white lithium NLGI Number 2 grease (Dow Corning® BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside surface of the filter before attaching it to the oil filter port (Figure 21). This will help seal the filter to the oil filter mounting bracket. See following NOTE.

NOTE: Use only Husqvarna oil filters (P/N 603 00 00-06) designed for this engine.

1. Snubber Bracket 2. Snubber 3. Compress Down

 

171

26

Figure 19 Compress Snubber Downward

Figure 20 Remove Engine Oil Filter

2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual

Page 33

Page 34 Page 36
Image 35
Page 34 Page 36
Contents HUV 4213-G and HUV 4213-GXP Page Page Foreword Regular Maintenance Items Periodic Maintenance ItemsTable of Contents Safety Decal and Feature Identification HUV 4213-G/4213-GXP HUV 4213-G/4213-GXP Proposition 65 State of California Practice SafetySafety Details General Warnings General WarningsModel Identification Serial Number Controls and IndicatorsFORWARD/REVERSE Control KEY SwitchForward/Reverse Handle Accelerator PedalChoke Brake PedalPark Brake Lockout CAMLOW OIL Warning Light Differential LockLight BAR Control Seat Latch and AdjustmentFuel GAUGE/HOUR Meter Headlight ControlPerformance Inspection PRE-OPERATION and Daily Safety ChecklistDriving Instructions Driving InstructionsStarting the Vehicle Parking and Leaving the Vehicle Stopping the VehicleFront Shock Absorbers BED Latch and Prop RODLoading and Unloading Transporting on a Trailer Towing with the VehiclePreparing the Vehicle for Extended Storage StorageGeneral Warnings on Returning the Stored Vehicle to ServiceMaintenance MaintenancePeriodic Service Schedule Periodic Service Schedule Regular Interval Semiannually by owner or Periodic Lubrication ScheduleBrake Fluid Master CylinderEngine OIL and Filter Change Engine OILEngine OIL Level Check Engine Oil Drain Plug and Pan Compress Snubber Downward Coat Rubber Seal OIL ViscosityExtended Storage on Fueling InstructionsFuel Tank BatteryBattery Electric Winch Accessory Cleaning the VehicleAccessories Subsequent Owner Registration Specifications HUV4213-GXP Vehicle SpecificationsLiquid Capacities Warranties WarrantyHOW to Make a Warranty Claim Your Warranty Rights and Obligations California Emission Control Warranty StatementItems Covered by this Warranty Husqvarna Forest & Garden Page Page Page 103372939
Top Page Image Contents