Husqvarna HUV 4213-GXP owner manual Fueling Instructions, Extended Storage on

Page 37

Fueling Instructions

NOTE: Using multi-grade oils (5W-20, 10W-30, and 10W-40) will increase oil consumption. Check oil level more frequently when using them.

FUELING INSTRUCTIONS

See General Warnings on page 9.

DANGER

•Turn the key switch to the OFF position before fueling.

•Do not pour fuel into the fuel tank when the engine is hot or while it is running.

•To help avoid electric arc caused by static electricity, the fuel storage/pumping device must be grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and during the fueling operation.

•If vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as shown (Figure 24).

•To help avoid the possibility of fire, clean up any spilled fuel before operating the vehicle.

CAUTION

•To allow for expansion, do not fill higher than 2.54 cm (one inch) from the top of the fuel tank. Avoid spilling fuel.

1.Remove the passenger seat.

2.Remove fuel cap and fill tank with fresh unleaded gasoline only. See preceding DANGER and CAUTION.

NOTE: Whenever possible, avoid using oxygenated fuels and fuels that are blended with alcohol. Vehicles to be stored for extended periods should be prepared for storage as instructed. See Preparing the Vehicle for

Extended Storage on page 24.

3.Replace fuel cap on tank. Ensure cap is tightened securely.

4.Clean any spilled fuel from the tank top and around the tank area.

5.Replace passenger seat.

WARNING

• Make sure seat hinges and latch are securely engaged before operating vehicle.

2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual

Page 35

Page 36 Page 38
Image 37
Page 36 Page 38
Contents HUV 4213-G and HUV 4213-GXP Page Page Foreword Regular Maintenance Items Periodic Maintenance ItemsTable of Contents Safety Decal and Feature Identification HUV 4213-G/4213-GXP HUV 4213-G/4213-GXP Proposition 65 State of California Practice SafetySafety Details General Warnings General WarningsModel Identification Serial Number Controls and IndicatorsFORWARD/REVERSE Control KEY SwitchForward/Reverse Handle Accelerator PedalPark Brake Brake PedalLockout CAM ChokeLOW OIL Warning Light Differential LockFuel GAUGE/HOUR Meter Seat Latch and AdjustmentHeadlight Control Light BAR ControlPerformance Inspection PRE-OPERATION and Daily Safety ChecklistDriving Instructions Driving InstructionsStarting the Vehicle Parking and Leaving the Vehicle Stopping the VehicleFront Shock Absorbers BED Latch and Prop RODLoading and Unloading Transporting on a Trailer Towing with the VehiclePreparing the Vehicle for Extended Storage StorageGeneral Warnings on Returning the Stored Vehicle to ServiceMaintenance MaintenancePeriodic Service Schedule Periodic Service Schedule Regular Interval Semiannually by owner or Periodic Lubrication ScheduleBrake Fluid Master CylinderEngine OIL Level Check Engine OILEngine OIL and Filter Change Engine Oil Drain Plug and Pan Compress Snubber Downward Coat Rubber Seal OIL ViscosityExtended Storage on Fueling InstructionsFuel Tank BatteryBattery Accessories Cleaning the VehicleElectric Winch Accessory Subsequent Owner Registration Specifications HUV4213-GXP Vehicle SpecificationsLiquid Capacities Warranties WarrantyHOW to Make a Warranty Claim Your Warranty Rights and Obligations California Emission Control Warranty StatementItems Covered by this Warranty Husqvarna Forest & Garden Page Page Page 103372939
Top Page Image Contents