Driving Instructions

Use the following checklist, in conjunction with the Pre-Operation and Daily Safety Checklist, as a guide to inspect the vehicle and check daily for proper operation. Any problems should be corrected by a Husqvarna distributor/dealer or a trained technician.

•Forward/Reverse shifter: Check for proper operation. See Controls and Indicators on page 11.

•Brakes: Be sure the brakes function properly. When brake pedal is fully pressed under moderate pressure, it should not go more than halfway to the floorboard, and vehicle should come to a smooth, straight stop. If the brake pedal goes more than halfway to the floorboard, or if the vehicle swerves or fails to stop, have the brake system checked and adjusted as required. When brake pedal is fully pressed under heavy pressure, pedal should feel firm and foot pad should be a minimum of 2 inches (5.1 cm) from floorboard. Brake adjustment must be maintained so the brake pedal cannot be pressed to the floorboard under any circumstance.

•Park brake: Apply moderate pressure to park brake handle. Tension should increase as the handle is pulled. When latched, the park brake should lock the wheels and hold the vehicle stationary (on an incline of 20% or less).

•Reverse buzzer: The reverse buzzer should sound as a warning when the Forward/Reverse handle is in the REVERSE position.

•Steering: The vehicle should be easy to steer and should not have any play in the steering wheel.

•Accelerator for pedal-start vehicle: With the key switch in the ON position and the Forward/Reverse handle in the FORWARD position, as the accelerator pedal is pressed, the engine should start and the vehicle should accelerate smoothly to full speed. When the pedal is released it should return to the original position and the engine stop.

Husqvarna vehicles operate at reduced speed in reverse.

•Accelerator for key-start vehicle: After starting the engine with the key switch and placing the Forward/Reverse handle in the FORWARD position, the vehicle should accelerate smoothly to full speed as the accelerator pedal is pressed. When the accelerator pedal is released it should return to the original position and the engine should idle.

•Governor: Check maximum vehicle speed. It should operate in forward at 17-19 mph (27-31 km/h) on a level surface.

•Differential lock cable: With the wheels at rest, pull the differential lock handle toward the rear of the vehicle (locked position). The differential lock arm at the other end of the cable should move approximately one-half inch (12.7 mm) downward. When the differential lock handle is placed back into the unlocked position, the differential lock arm should move approximately one-half inch (12.7 mm) upward.

•General: Listen for any unusual noises such as squeaks or rattles. Check the vehicle’s ride and performance. Have a Husqvarna dealer or a trained technician investigate anything unusual.

DRIVING INSTRUCTIONS

WARNING

•Only licensed drivers should be allowed to drive the vehicle.

•Before allowing anyone to drive the vehicle, make sure the driver is familiar with all controls and operating procedures.

•No one under the age of 16 years should be allowed to drive the vehicle.

•No more than one person per bucket seat at one time, or two persons per bench seat.

•Do not allow riders in the cargo bed.

•For night use, the vehicle must be equipped with headlights, taillights, and reflectors.

•The vehicle is not specially equipped for handicapped persons:

–Be sure all persons can properly operate the vehicle prior to allowing them to drive the vehicle.

WARNING CONTINUED ON NEXT PAGE

Page 18 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual