Honda Power Equipment GA3.6HA GA-3.6H Series- Controls and Indicators, Generators Components

GA-3.6H Series— CONTROLS AND INDICATORS

Figure 2A. Generators Components

1.	Lifting Bail Eye – Attach a rope or chain to this lifting eye
	when lifting of the generators is required. Never stand
	underneath the generators while it is being lifted. Place
	lifting eye in down position when not in use.
2.	AC-Voltmeter – This voltmeter indicates (with a mark) the
	rated 60 Hz (single-phase) output voltage. In addition the
	voltmeter can also be used as a diagnostic tool. If the
	voltmeter indicator (needle) is below the rated voltage,
	engine problems may exist (low/high RPM's). To prevent
	damage to the generators or power tools turn the generators
	OFF and consult your authorized Multiquip service dealer.
3.	Idle Control Switch – The generators are provided with
	an automatic idle control device for noise suppression and
	reduced fuel consumption. The automatic idle control
	automatically engages under a no-load condition. With the
	automatic idle control switched “ON”, the engine revolutions
	will automatically drop to about 2600 rpm (low-speed
	operation) within 3 seconds after the load stops. When the
	operation is resumed, the engine speed is automatically
	increased to about 3600 rpm (high-speed operation) as
	soon as the load is connected.
4.	Operation Switch – Place this rocker switch in the "ON"
	position (up) for normal operation.To turn-off the generators,
	place the operation switch in the "OFF" position (down).

5.GFCI Duplex Receptacle – NEMA 5-20R, GFCI receptacle will provide 120V, 20 amps. (GA-3.6HA has two.)

6. 120V Output Receptacle – NEMA L5-20Rtwist-lock receptacle will provide 120V, 20 amps, 60 Hz.

7. 120V Output Receptacle – NEMA L5-30Rtwist-lock receptacle will provide 120V, 30 amps, 60 Hz.

8. 120V/240V Output Receptacle – NEMA L14-30R twist- lock receptacle will provide (120V, 50 amps, or 240V, 25 amps, 60 Hz.)

9. Main Breaker – This 2-pole circuit breaker (120/240V,

13.5amps) protects the generators from short circuiting or overloading. When starting the generators always have the circuit breaker placed in the "OFF" position.

10. Ground – This ground connection point should be connect to a good earth ground (ground rod). GA-3.6H and GA3.6HA models only

GA-3.6H SERIES A.C. GENERATORS — OPERATION & PARTS MANUAL — REV. #0 (11/01/05) — PAGE 15