Honda Power Equipment GA3.6H GA-3H/HA Series PRE-INSPECTION Engine, Before Starting, Fuel Check

Page 22

GA-3H/HA Series — PRE-INSPECTION (ENGINE)

CAUTION

NEVER operatethegenerators in a confined area or enclosed area structure that does not provide ample free flow of air.

ALWAYS wear approved eye and hearing protection before operating the generator.

Before Starting

1.Read safety instructions at the beginning of manual.

2.Clean the generator, removing dirt and dust, particularly the engine cooling air inlet, carburetor and air cleaner.

3.Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required.

4.Check carburetor for external dirt and dust. Clean with dry compressed air.

5.Check fastening nuts and bolts for tightness.

Engine Oil Check

1.To check the engine oil level, place the generators on secure level ground with the engine stopped.

2.Remove the filler dipstick from the engine oil filler hole (Figure 6) and wipe clean.

Figure 6. Engine Oil Dipstick (Removal)

3.Insertandremovethedipstickwithoutscrewingitintothefiller neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 7), fill to the edge of the oil filler hole with the recommended oil type (Table 4).Maximum oil capacity is 1.16 quarts (1.1 liters)

Figure 7. Engine Oil Dipstick (Oil Level)

Table 4. Oil Type

Season

Temperature

Oil Type

 

 

 

Summer

25°C or Higher

SAE 10W-30

 

 

 

Spring/Fall

25°C~10°C

SAE 10W-30/20

 

 

 

Winter

0°C or Lower

SAE 10W-10

 

 

 

DANGER EXPLOSIVE FUEL

Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel the generators if the engine is hot! , running or in the dark.

Fuel Check

1.Close the fuel cock before filling the fuel tank.

2.Remove the fuel cap located on top of fuel tank.

3.Readthefuelgaugelocatedontopofthefueltank(Figure8)to determin if the fuel level is low. If fuel is low, replenish with clean unleaded fuel.

Figure 8. Fuel Gauge

4.When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. DO NOT fill the tank beyond capacity. Wipe up any spilled fuel immediately!

PAGE 22 — GA-3.6H SERIES A.C. GENERATORS — OPERATION & PARTS MANUAL — REV. #0 (11/01/05)

Image 22
Contents Model GA3.6H Series Page Page Table of Contents Best Deal! Order via Internet Dealers Only Order via Fax Dealers OnlyBurn Hazards GA-3.6H Series Safety Message Alert SymbolsRespiratory Hazards Equipment Damage Always wear approved eye and hearing protectionRotating Parts Hazards GA-3.6H Series Rules for Safe Operation Read this manualMaintenance Safety Keeping with Multiquips policy GA-3.6H Series- Rules for Safe OperationEmergencies GA-3.6H Series- Specifications GENERATOR/ENGINE Effects of Altitude and HeatGA-3.6H Series- Dimensions DimensionsGA-3.6H Series General Information Small Motors Single Phase Load 60 HzIncandescent Loads Large MotorsGA-3.6H Series- Controls and Indicators Generators ComponentsV Full Power Switch Simplified Diagram Up Position To GA3.6HZ onlyGA-3.6H Series- Controls and Indicators Models GA3.6H and GA3.6HA shownGA-3.6H Series Generator Refueling Generators RefuelingIndoor Installation GA-3.6H Series InstallationOutdoor Installation MountingGA-3.6H Series Installation Connecting the GroundExtension Cable General Inspection Prior to Operation Ground Power ToolsGA-3.6H Series PRE-INSPECTION Main Circuit BreakerEngine Oil Check GA-3H/HA Series PRE-INSPECTION EngineBefore Starting Fuel CheckGA-3.6H Series- Initial START-UP Engine Before Starting the EngineWhen the full power switch is in the 120 Place the full power switch in the 120V position upPlace the full power switch in the 240V position down Stopping the Engine Place the idle control switch in the OFF positionWhen using a combination of dual Place the main circuit breaker in the OFF positionGA-3.6H Series- Preparation for Longterm Storage Generators StorageGA-3.6H Series- Maintenance Engine Engine Maintenance ScheduleEngine Air Cleaner Spark Plug GapGA-3.6H Series Wiring Diagram 3.6HZ GA-3.6HZ Wiring DiagramGA-3.6H Series-WIRING Diagram 3.6H GA-3.6H Wiring DiagramGA-3.6HA -WIRING Diagram Generator GA-3.6HA Wiring DiagramGA-3.6H Series-TROUBLESHOOTING Engine Engine TroubleshootingWhite GA-3.6H Series-TROUBLESHOOTING Generator Generator TroubleshootingPage Part NO. Column GA-3.6H Series- Explanation of Code in Remarks ColumnNO. Column QTY. ColumnGA-3.6H Series- Suggested Spare Parts DescriptionGA-3.6H Series- Nameplate and Decals Nameplate and DecalsGA-3.6H only GA-3.6H Series Nameplate and DecalsGA-3.6HZ only GA3.6HA onlyGA-3.6H Series- Generator Assy Generator AssyGA-3.6H Series- Generator Assy GA-3.6H Series Control BOX ASSY. GA-3HZ Control BOX ASSY. GA3.6HZGROMMET, G3 Operation SWITCH, ET210K12Control BOX Slow Down UNIT, ND-80GA-3.6H Series Control BOX ASSY. GA-3H Control BOX ASSY. GA-3HOperation SWITCH, C1550WA Full Power SWITCH, ET-330D12Idle Control SWITCH, C1550WA GROMMET, G-3GA-3.6H Series Control BOX ASSY. GA-3.6HA Control BOX ASSY. GA-3.6HACircuit BREAKER, KM-2 13.5A GA-3.6H Series Control BOX Assy .6HARECEPTACLE, L14-20R GA-3.6H Series- Muffler Assy Muffler AssyBracket MufflerBolt HEX Head HEX NUTGA-3.6H Series Pipe Frame ASSY. GA-3HZ Pipe Frame ASSY. GA3.6HZRubber Suspension Pipe FrameBase Fuel TankGA-3.6H Series- Pipe Frame ASSY. GA-3.6H/GA3.6HA Pipe Frame ASSY. GA3.6H/GA3.6HAHanger GA-3.6HA onlyCAP, Fuel Tank Plain WasherHonda GX240K1EDN2 Engine AIR Cleaner Assy AIR Cleaner AssyHOUSING, AIR Cleaner ELEMENT, AIR CleanerSEPARATOR, AIR Cleaner STAY, AIR CleanerHonda GX240K1EDN2 Engine Camshaft Assy Camshaft AssyLIFTER, Valve SPRING, Weight ReturnARM, Valve Rocker PIVOT, Rocker ARMHonda GX240K1EDN2 Engine Carburetor Assy Carburetor AssyGasket SET GASKET, AIR CleanerCLIP, Wire Harness Valve SET, FloatHonda GX240K1EDN2 Engine Control Assy Control AssyROD, Governor SPRING, Control AdjustingARM, Governor SPRING, GovernorHonda GX240K1EDN2 Engine Crankcase Cover Assy Crankcase Cover AssyPIN, Governor Weight WEIGHT, GovernorHOLDER, Governor Weight GASKET, Case CoverHonda GX240K1EDN2 Engine Crankshaft Assy Crankshaft AssyCrankshaft E-TYPE 96100620600013310ZE2701 90741ZE2000Honda GX240K1EDN2 Engine Cylinder Barrel Assy Cylinder Barrel AssySHAFT, Governor ARM Switch ASSY., OIL LevelWIRE, Ground BOLT, Drain PlugHonda GX240K1EDN2 Engine Cylinder Head Assy Cylinder Head AssyCLIP, Valve Guide GUIDE, Valve OS OptionalGUIDE, EX. Valve OS Optional GASKET, Cylinder HeadHonda GX240K1EDN2 Engine FAN Cover Assy FAN Cover AssyShroud COVER, FAN *NH1* BlackGROMMET, Drain Hole Honda GX240K1EDN2 Engine Flywheel Assy Flywheel AssyFAN, Cooling Honda GX240K1EDN2 Engine Ignition Coil Assy Ignition Coil AssyWIRE, Stop Switch 470MM CLAMP, WireGROMMET, Wire HOLDER, Stop Switch WireHonda GX240K1EDN2 Engine Piston Assy Piston AssyPiston OS 0.25, Optional BOLT, Connecting RODPiston STD Piston OS 0.50, OptionalHonda GX240K1EDN2 Engine Recoil Starter Assy SPRING, Friction PULLEY, Recoil StarterRATCHET, Starter SPRING, Starter ReturnHonda GX240K1EDN2 Engine Solenoid Assy Solenoid AssySTAY, Solenoid Throttle CAP, Choke LeverSPRING, Choke Return LEVER, Solenoid ThrottleHonda GX240K1EDN2 Engine Labels Assy Labels AssyMARK, Choke MARK, AIR CleanerEmblem MARK, OIL CautionEffective October 1, 2002 Terms and Conditions of Sale Parts Page Heres HOW to GET Help