Powermate P1204 owner manual General Safety Guidelines

Page 4

GENERAL SAFETY GUIDELINES (Continued)

 

 

 

 

 

 

 

 

 

 

 

 

WARNING:

 

 

 

CAUTION:

 

 

 

 

 

 

 

 

 

The National Electrical Code (NEC) requires the frame and external electrically conductive parts of the generator to be connected to an approved earth ground.

Keep a fire extinguisher near the generator at all times. Extinguishers rated "ABC" by the National Fire Protection Association are appropriate for use on the standby electric system. Keep the extinguisher properly charged and be familiar with its use. If you have any question pertaining to fire extinguishers, consult your local fire department.

Generator/engine noise can cause hearing loss. Never operate the generator set without a muffler or with a faulty exhaust system. Always wear hearing protection when near or operating the generator.

DO NOT permit anyone to operate the standby electric system without proper instruction.

In case of accidents caused by electric shock, immediately shut down the source of electrical power. If this is not possible, attempt to free the victim from the live conductor. AVOID DIRECT CONTACT WITH THE VICTIM. Use a nonconducting implement, such as a rope or board, to free the victim from the live conductor. If the victim is unconscious, apply first aid and get immediate medical help.

Units with broken or missing parts, without protective housing or covers should never be operated. Contact your service center for replacement parts.

Inspect the generator regularly, and contact your nearest Authorized Dealer for parts needing repair or replacement.

Never use the generator or any of its parts as a step. Stepping on the unit can stress and break parts, and may result in dangerous operating conditions from leaking exhaust gases, fuel leakage, oil leakage, etc.

Thoroughly read the OPERATORS MANUAL before operating the generator. Safe operation and top performance can be obtained only when equipment is operated and maintained properly.

Ensure that enclosure doors are closed and locked at all times other than during service.

4

200-2667

Image 4
Contents Stationary Standby Electric Generator Model Series P1204Table of Contents General Safety Guidelines General Safety Guidelines Introductio N Installation Plannin GUnpacking Instruction S Generator Specifications P120401 12 KWInstallation Drawings Location and Generator Generator InstallationPlacemen T Placement and Anchoring Utomatic Transfer Switch Electrical Hookup AIN Line Output Powe RGenerator Start Signal Utility Circuit SupplyWiring Diagram Fuel Specifications Consumption Require MentsFuel Hooku P Fuel RequirementsNatural Gas NG Battery Placement Battery Requirement SConnectio N Nnection con t LubricationFirst Time Startup Generator Operatio NCircuit Breaker Control Panel Feature SFuses Generator Control Panel Operatio N Starting the GeneratorCyclic Crank RUN StateStatus Indicators FaultsMaintenance Engine OIL Level Check Upper Limit Lower LimitEngine OIL Cooler Inspection ND Clean ING Engine OIL and OIL Filter HangeBattery Maintenanc E Engine AIR Filter ChangeTT ERY Maintenanc E con t Spark Plug Chec KAdjustmen T Nclosure and SiteValve Clearance Check Fuel System InspectionTroubleshooting Symptom Possible Cause Corrective ActionTroubleshooting 200-2667 Powerstation Automated Power System Limited Warranty Contact the Powermate Product Service Department AT