Sears 536.886331 owner manual HOW to USE Your Snow, To Stop Your Snow Thrower

Page 12

OPERATION

The operation of any snow thrower can result in foreign objects being thrown into the eyes, which ca. result in severe eye damage. Always wear safety glasses or eye shieJds while operating the _now thrower.

We recommend standard safety glasses or wide vision safety mask for over your glasses available at SEARS Retail Stores or Service Centers.

HOW TO USE YOUR SNOW

THROWER

TO STOP YOUR SNOW THROWER

To stop throwing snow, release the auger drive lever (See FIG. 4).

To stop the traction drive, release the traction drive lever. (See FIG. 4)

To stopthe engine, push the throttle control lever to off and pull out the ignition key (See FIG. 3).

NOTE: Do not turn key.

TO CONTROL SNOW DISCHARGE

Turn the crank assembly to set the direction of the snow throwing.

Adjust snow chute deflector to set the distance. Push remote lever forward to discharge snow high and far Pull remote lever back to discharge snow down. (FIG. 2).

TO MOVE FORWARD AND BACKWARD

To shift, release the traction drive lever and move the speed shifter lever to the speed you desire. Ground speed is determined by snow conditions. Select the speed you desire by moving the speed shifter lever into the appropriate area on the controt panel.

Speeds 1, 2 - Wet, Heavy, Extra Deep Speed 3 - Moderate

Speeds 4, 5 - Very Light Speed 6 - Transpod only

Engage the traction drive lever (See FIG. 4, left hand). As the snow thrower starts to move, maintain a firm hold on the handles, and guide the snow thrower along the clearing path. Do not attempt to push the snow thrower.

TO move the snowthrower backward, movethe speed shifter lever into first or second reverse and engage the traction drive lever (left hand/

IMPORTANT: NEVER MOVE THE SPEED SHIFTER LEVER WHILE THE TRACTION LEVER IS DOWN

TO THROW SNOW

Push down the auger drive lever (See FIG. 4, right hand)

Release to stop throwing snow

TRACTION DRIVE

AUGER DRIVE

LEVERLEVER

OFF

ON,OFF --7-" " . "--; o

LEFT

_

_l

RIGHY

HAND

 

 

HAND

FIG. 4

CAUTION: READ OWNER'S MANUAL

BEFORE OPERATING MACHINE.

NEVER DIRECT DISCHARGE TOWARD

BYSTANDERS. STOP THE ENGINE BE-

FORE UNCLOGGING DISCHARGE

CHUTE OR AUGER HOUSING AND BE-

FORE LEAVING THE MACHINE.

t,3

Image 12
Contents When Ordering Repair PARTS, Always Give the Following Information Product Snow ThrowerModel Number Engine Model Number Part Number Part DescriptionFuel Safety Operating SafetyBefore USE Safety Rules REPAIR/ADJUSTMENTS SafetySafe Storage Aintenance Agreement Jstomer ResponsibilitiesSpark Plug Table of Contents Contents of Hardware Pack Assembly Tools Required for AssemblyTo Remove Snow Thrower Measuring tape or ruLerHOW to SET UP Your Snow Thrower To Install the Upper Handle and Crank AssemblyTo Assemble Snow Chute Roll snow thrower off the skid by pulling on the handleTo Install Headlight PLASTIC\ NotchedsectionTo Assemble Control Cables Parts section of this manualTo Install the Shifter Lever To Install Shifter Lever KnobOperation VerseHOW to USE Your Snow ThrowerTo Stop Your Snow Thrower To Move Forward and BackwardOperation Before Starting the EngineTo USE Wheel Lockout PIN Fill OILRun the engine at full throttle RUN when throwing To Stop EngineWarm Start RequiredTo Start Engine Recoil Starter Frozen Recoil StarterSnow Throwing Tips Service Records Schedule General Recommendationslubrication ChartService Dates Customer ResponsibilitiesSnow Thrower Lubrication Every TEN HoursLubrication Every 25 Hours Engine LubricationRecommended Viscosity Grades COLDER--i2 --WARMER 5W30SAE30Service and Adjustments To Adjust Skid HeightTo Adjust Scraper BAR To Adjust Chute Crank AssemblyService AdjustmentsTo Adjust the Clutch Control Cables To Adjust BeltsTo Replace Belts Auger Drive BeltDOORS, Away from Fire or Flame To Adjust the Belt Guides To Adjust the Friction WheelTraction Drive Belt Remove the belt cover See in this sectionTo Replace Friction Wheel Away from Fire or FlamfRemove the bottom panel See FIG LBOTTOMPANELTo Adjust Carburetor To Replace Auger Shear BoltLocknut To Adjust or Replace To AdjustSpark Plug To ReplaceStorage Snow Thrower StorageEngine Storage OtherTrouble Shooting Points TroubleCause Correction