SERVICE AND
TO ADJUST THE CLUTCH CONTROL CABLES
Periodic adjustment of the cables may be required due to normal stretch and wear on the belts. To check for correct adjustment, the control lever must be in the full forward position, resting on the plastic bumper, The control cables are correctly adjusted when the center of the "Z" Fitting is between the center and top of the hole in the clutch lever and there is no droop in the _,abie (See FIG. 3).
If adjustment is necessary:
•Remove gas from gas tank, Stand blower on end.
•Disconnect the "Z" Fitting from drive lever.
•Pull spring cover up to expose spring. Push the cable through the spring (See FIG. 4) to expose the threaded
portion of the cable.
•Hold the square end ofthe threaded portion with pliers and adjust the Iocknut in until the excess slack is removed (See FIG. 4 inset)
•Pullthe cable back throughthe spring andconnect the cable. Do the same for the other lever cable.
NOTE: Whenever the traction drive or auger belts are adjusted or replaced, the cables will need to be adjusted.
TO ADJUST BELTS
ADJUSTMENTS
TRACTION DRIVE | CONTROL | LEVER | |
LEVER | MUST BE IN FULL | ||
FORWARD | POSI- | ||
"Z" FITTING | |||
TION (Just | Contact- | ||
| |||
| Plastic | Bumper) | |
| WHEN CHECKING | ||
PLASTIC BUMPER
FIG. 3
FIG. 4
Belts stretch during normal use. If you need to adjust the belts due to wear or stretch, proceed as follows:
TRACTION DRIVE BELT (See FIG. 6)
The traction drive belt has constant spring pressure and does not require adjustment. Check the clutch control cable adjustment before replacing the belt.
Replace the traction drive belt if it is still slipping (See To
Replace Belts paragraph in this section).
AUGER DRIVE BELT (See FIG. 6)
If your snow thrower will not discharge snow, check the control cable adjustment. If it is correct, then check the condition of the auger drive belt. It may be loose or damaged, If it is damaged, replace it. See To Replace Belts paragraph lin this section. If the auger drive belt is loose, adjust as follows:
•Disconnect the spark plug wire.
•Remove the belt cover (See FIG. 7 in this section).
•Loosen the nut on the idler pulley (See FIG. 5) and move the pulley toward the belt about 1/8".
•Tightenthe nut.
•Press the auger drive lever. Check the tension on the belt (opposite idler pulley). The belt should deflect about 1/2" with moderate pressure (See FIG. 5).
NOTE: You may have to move the idler pulley more than once to obtain the correct tension.
•Replace the belt cover.
IDLER
ENGAGED _
|
| R |
|
| FIG. 5 |
TRACTION | DRIVE BELT |
|
TRACTION | DRIVE | DE |
PULLEY | (Left Hand) | |
|
| DRIVE |
(Right Hand) | PULLEY | |
TRACTION |
| |
DRIVE | IDLER | |
IDLER | PULLEY | PULLEY |
FIG. 6
•Check the clutch control cable adjustment
•Reconnect the spark plug wire.
21