SERVICE AND ADJUSTMENTS
I
CAUTION: ALWAYS DISCONNECT THE I SPARK PLUG WIRE AND TIE BACK AWAY FROM THE PLUG BEFORE MAK- ING ANY ADJUSTMENTS OR REPAIRS.
SKID MOUNTING NUTS
TO ADJUST SKID HEIGHT
This snow thrower is equipped with two height adjustment skids, located on the outside of the auger housing (See FIG. 1). These skids elevate the frontof the snow thrower. For normal hard surfaces such as a paved driveway or walk, adjust the skids as follows:
•Check tire pressure (14 to 17 pounds). See side of tire for maximum inflation. Do not exceed maximum
pressure on side of tire.
•Place the extra shear bolts supplied (found in parts
bag) under each end of the scraper bar near but not under the skid.
•Loosen the skid mounting nuts (See FIG. 1) and adjust the skids up to bring the front of the snow thrower down.
•Set the skid on the other side at the same height. For rocky or uneven surfaces, adjust the skids as follows:
•Raise the front of the snow thrower by moving the skids down. This will help prevent rocks and other debris from being picked up and thrown by the auger.
NOTE: Be sure that snow thrower is set at same height on both sides.
TO ADJUST SCRAPER BAR
After considerable use, the metal scraper bar will have adefinite wear pattern. The scraper bar in conjunction with the skids should always be adjusted to allow 1/8" between the scraper bar and the sidewalk or area to be cleaned.
•Position the snow thrower on a level surface.
•Loosen the carriage bolts and nuts securing the scraper bar to the auger housing.
Adjust the scraper bar to the proper position.
Tighten the carriage bolts and nuts, making sure that the scraper bar is parallel with the working surface.
CAUTION: BE CERTAIN TO MAINTAIN PROPER GROUND CLEARANCE FOR
YOUR PARTICULAR AREA TO BE
&GRAVEL, ROCKS OR OTHER DEBRIS, IF STRUCK BY THE IMPELLER, MAY BE THROWN WITH SUFFICIENT FORCE TO
CAUSE PERSONAL INJURY, PROPERTY
DAMAGE OR DAMAGE TO THE SNOW
THROWER.CLEARED. OBJECTS SUCH AS
O
AUGER HOUSING | HEIGHT ADJUST SKID |
FIG. 1
After extended operation, the scraper bar may be reversed. If the scraper bar must be replaced due to wear, remove the carriage bolts and nuts and install a new scraper bar.
TO ADJUST CHUTE
CRANK ASSEMBLY
If you cannot rotate the chute crank fully to the left and to the right, you need to adjust the chute crank (See FIG. 2).
•Loosen both 1/2" nuts on the crank adjusting rod (using 3/4" wrenches).
•Rotate the adjusting rod in or out to allow about 1/8"
clearance between the notch in the flange and the outer diameter of the worm.
•Once this clearance is set, tighten the nuts.
NOTE: Be sure the crank does not touch the side of the engine or the cover will be scratched.
PLASTIC _ | _ | NOTCHED SECTION |
OAF COTTER
IJ
FLATWASHER
1/2 INCH
CRANK ADJUSTING ROD
WORM
FIG. 2