Sears 944.529571 owner manual Operati, Meets A.N.SJ. Safety Requirements

OPERATI

GASOLINE

FILLER CAP

MUFFLER

CHOKE

CONTROL

PRIMER

SAFETY iGNiTiON

KEY

THROTTLE

NOTE: iTEMS ABOVE

ARE SHOWN IN

THEIR TYPICAL

LOCATION ON THE

ENGINE, ACTUAL

LOCATION MAY

VARY WITH THE

ENGINE ON YOUR

UNIT,

AUGERS

			DISCHARGE	DEFLECTOR
	AUGER	DRIVE	CHUTE	REMOTE
	CONTROL	SPEED	CONTROL	CONTROL
	LEVER	CONTROL	LEVER	LEVER
ELECTRIC		LEVER
START	CHUTE
BUTTON
RECOIL	DEFLECTOR			TRACTION
				DRIVE
STARTER				CONTROL
HANDLE				LEVER
				=H TURN
				TRIGGER
DISCHARGE
CHUTE
ON/OFF
SWITCH
CLEAN=OUT				HANDLE
TOOL
				KNOB
				MUFFLER
				TOOLBOX

P LATE

FIG, 10

MEETS A.N.SJ. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards institute.

Toolbox - used to store spare shear bolts, Iocknuts and wrench.

Safety ignition key = must be inserted for the engine to start and run. Remove when snow thrower is not in use.

Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
LH and RH turn triggers =used to steer the snow thrower.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Primer = pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
ON / OFF switch - used to STOP the engine.	10

Choke control = used for starting a cold engine. Throttle= used to select FAST or SLOW engine speeds.

Traction drive control lever - used to engage power-pro- pelled forward or reverse motion of snow thrower.

Auger control lever - used to engage auger motion (throw

snow).

Deflector remote control lever = used to change the distance the snow is thrown.

Discharge chute control lever = used to change the di- rection the snow is thrown.

Skid plate = used to adjust height of scraper bar from the ground.