Sears 944.529571 owner manual Check TiRE Pressure

Page 8

ASSE BLY/PRE-OPERATION

iNSTALL CHUTE DEFLECTOR REMOTE CONTROL

(See Figs. 8 and 9)

1.Install remote cable bracket to discharge chute with 5/16-18 carriage bolt and 5/16-18 Iocknut as shown. Tighten securely.

2.Install remote cable eyelet to chute deflector with 1/4-20 shoulder bolt and 1/4-20 Iocknut as shown. Tighten nut securely. Cable eyelet will be loose on shoulder bolt.

3.Install spring hooks between hex nuts on chute rotater head and into hole in chute deflector as shown.

1/4-20	SPRING
	CHUTE
SHOULDER	DEFLECTOR

1/4-20

LOCKNUT f_

5/16-18

CARRIAGE

CABLE

EYELET

REMOTE

/CABLE

/BRACKET

5/16-18

LOCKNUT

FIG. 8

CHECK TiRE PRESSURE

The tires on your snow thrower were overinflated at the fac- tory for shipping purposes. Correct and equal tire pressure is important for best snow throwing performance.

•Reduce tire pressure to 14-17 PSI.

CHUTE DEFLECTOR CONTROLLEVER

FIG, 9

8

Image 8

Contents OW TH SE IES E E 27 TWO-STAGEPowe -P Elle Safe Operation Practices for Walk-Behind Snow Throwers Contents Page Shearboltsandnuts Parts Packe ELY I CartonOperatio Install Traction Drive Control ROD Asse BLY/PRE-OPERATIONUnfold Upper Handle See FigsOperatic Install Discharge Chute / Chute RotaterASS Check TiRE Pressure Know Your Snow Thrower Or WarningIgnition KEY RUN Pull OUT to Stop DisengagedMeets A.N.SJ. Safety Requirements OperatiTo unclo the chute and/or au er HOW to USE Your Snow ThrowerTimes including startup Operation To Throw Snow See FigBefore Starting the Engine To Start Engine Before StoppingGeneral Recommendations Before Each USESnow Thrower Fill in DatesCleaning EngineEquipment shear bolts as supplied with your snow thrower To Adjust Snow Thrower HeightSeadj Ents Seadj Carburetor Engine SpeedStorage OtherFuel System Engine OILProblem OTI\17 DESCRiPTiON KEY Part Description DescriptionDescription Skid Plate LH Skid Plate RH Description Auger Bearing Bearing PlugControl Panel / Discharge Chute PartDescription Handles InterlockRepair Partssnow Thrower - Model Number 944,529571 SpacerImpeller ROD Assembly Traction ROD AssemblyShifter ROD TOP Shifter ROD BottomWire Harness Lower TubePivot Support Panel ConsoleRepair Parts Snow Thrower - Model Number 944,529571 Drive Rubber Ring Assembly Drive Plate AssemblySpeed Selector Wheel HUBAxle Assembly Axle ShaftSprocket TH Rust Wash ERChassis / Pulleys KEY Part DescriptionEngine Mount Plate Engine ModelCover Assembly Impeller Idler PulleyENG Impeller Idler ARMSteering Bracket Pivot BracketWheel Driver BellcrankCable Bracket Wheel AssemblyPart Description Safety Ignition KEY BAG of PartsKEY Part NO. no Locknut 3/8-16 Washer 3/8Decals KEY PartBriggs & Stratton 4-CYCLE Engine 161Model Number 20M314-1370-E2 528j!i Briggs & Stratton Cycle EngineEngine Power Rating information Service Notes 800-.4-.MY-.HOME