Sears 270-3250 owner manual Air Filter Maintenance

Page 23

After you have drained the dirty oil, refill the crankcase with fresh auto motor oil. To fill

the crankcase, perform the steps listed in the "Checking/Adding Oil" portion of this

MAINTENANCE section.

NOTE: Never dispose of used motor oil in the trash or down a drain. Please call

your local recycling center or auto garage to arrange oil disposal.

Air Filter Maintenance

TIMELINE: Clean the air filter every 50 hours or more often in dirty environments.

To clean the air filter:

1.Unscrew the wing nut from the top of the air filter and remove the plastic case (see figure 19).

2.Unscrew the wing nut that holds the metal air filter bracket to the machine. Remove the metal bracket with sponge attached.

3.Slide the sponge element off of the metal bracket. Wash the sponge element in household detergent and warm water. Allow to dry.

4.Soak the dry element in engine oil. Squeeze out any excess oil.

5.Tap the metal bracket, with paper air filter inside, against a hard surface to knock out any dirt.

6.Slide the sponge element back onto the metal bracket.

7.Replace the metal bracket and secure with the inner wing nut. Then replace the plastic cover and secure with the outer wing nut.

@

Figure 19- Removing the air filter

23

Image 23
Contents Snow Thrower Contents General Safety Procedures Page Page Package Contents Snow Thrower Components Engine Components Chute Assembly AssemblyAttaching Drive Speed Control Lever Chute Rotation Handle Cable attachment Preparing the Snow Thrower for USE 9399U Adjust Skid Shoes Engine lever positions OperationUsing the Snow Thrower Chute Deflector Stopping the Snow Thrower MAINTENANCE/CARE Checking Tire Pressure Rephtcing the Oil Air Filter Maintenance Spark Plug Maintenance Adjusdng Drh,e and Auger Cables Replacing Shear Pins ProblemCauseSolution TroubleshootingOose 100 List Snow Thrower Parts@ @ Engine Parts List 2ARBETRETOR Limited Warranty for Yardworks sSNOW Thrower