Sears 270-3250 owner manual Rephtcing the Oil

Page 22

that performs well in cold conditions. The telnperamre conditions and recommended oil grade will vary by geographic area.

. Once you have ensured the engine oil level is correct, replace the oil filler cap and screw tightly.

Figure 16- Removing oil filler cap

Figure 17- Proper oil level

Rephtcing the Oil

TIMELINE: You should drain and replace the oil in the crankcase every 50 hours or when dirty.

To drain the oil from the crankcase:

1.Place a bucket near the engine to catch oil as it drains.

2.Using a wrench, unscrew the oil drain plug. The oil drain plug is located just below and to the left of the oil filler cap as shown in figure 18. Allow all the oil to drain from the crankcase.

3.Replace the oil drain plug and tighten with the hex wrench.

Figure 18- Draining the oil

22

Image 22
Contents Snow Thrower Contents General Safety Procedures Page Page Package Contents Snow Thrower Components Engine Components Assembly Chute AssemblyAttaching Drive Speed Control Lever Chute Rotation Handle Cable attachment Preparing the Snow Thrower for USE 9399U Adjust Skid Shoes Operation Engine lever positionsUsing the Snow Thrower Chute Deflector Stopping the Snow Thrower MAINTENANCE/CARE Checking Tire Pressure Rephtcing the Oil Air Filter Maintenance Spark Plug Maintenance Adjusdng Drh,e and Auger Cables Replacing Shear Pins Troubleshooting ProblemCauseSolutionOose 100 Snow Thrower Parts List@ @ Engine Parts List 2ARBETRETOR Limited Warranty for Yardworks sSNOW Thrower