Cub Cadet 933 SWE Wheel Making Adjustments, Skid Shoes, Chute Bracket Adjustment, Auger Control

Skid Shoes

The space between this shave plate and the ground can be adjusted. For close snow removal, place skid shoes in the low position. Use middle or high position when area to be cleared is uneven.

1.Adjust skid shoes by loosening the six hex nuts, washers, and carriage bolts and moving skid shoes to desired position. See Figure 5-5.

2.Make certain the entire bottom surface of skid shoes are against the ground to avoid uneven wear on the skid shoes.

3.Tighten nuts and bolts securely.

Chute Bracket Adjustment

If the spiral at the bottom of the chute directional control is not fully engaging with the chute assembly, the chute bracket can be adjusted. To do so:

1.Loosen the two nuts which secure the chute bracket and reposition it slightly. See Figure 5-6.

2.Retighten the nuts.

Auger Control

To adjust the auger control, refer to the section in this manual titled “Setting Up Your Snow Thrower”.

5

Friction

Wheel Making Adjustments

Drive	Axle Supp.
Plate	Brkt.
	Opening

Figure 5-4

IMPORTANT: It is not recommended that you operate this snow thrower on gravel as loose gravel can be easily picked up and thrown by the auger causing personal injury or damage to the snow thrower.

	If for some reason,
	you have to operate
Figure 5-5	the snow thrower on
	gravel, keep the skid
	shoe in the highest
	position for maximum
	clearance between the
	ground and the shave
	plate.

Figure 5-6

15