Cub Cadet 933 SWE, 930 SWE warranty Maintaining Your Snow Thrower, Drive Belt

If also replacing the drive belt, proceed to the “Drive Belt” instruction. If not, reassemble by performing the previous steps in the opposite order and manner of removal.

Proper Adjustment: With the auger clutch lever in the disengaged position, the top surface of the new belt should be even with the outside diameter of the pulley.

1.To adjust, disconnect ferrule from brake bracket as- sembly and thread ferrule in (towards idler) to increase tension on belt, and out to decrease tension.

NOTE: The brake puck must always be firmly seated in the pulley groove when auger control is disengaged.

Drive Belt

1.Pull the idler pulley away from the backside of the drive belt to relieve the tension and slide the drive belt off the idler pulley (If necessary unhook the extension spring from the belt cover plate). See Figure 6-12.

2.Roll the drive belt off the lower drive pulley.

3.Remove the belt from the engine pulley.

4.Install the new belt on the pulleys in the reverse order and re-tension with the idler pulley.

5.Reassemble by performing the previous steps in the opposite order and manner of removal.

1 3

2

Figure 6-12

6

Maintaining

Your Snow

Thrower

Figure 6-9

Specifications are subject to change without notification or obligation. Images may not reflect your exact model and are for reference purposes only.

Figure 6-10

B

C

A

Figure 6-11

19