Ariens 926042 quick start Step Two Install Discharge Chute

Page 3

Step Two:

Install Discharge Chute

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from auger housing.

3.Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above.

NOTE: Leave discharge chute pedestal loose to help install the chute rod.

Image 3

Contents Quick Start Guide Step One Unfold Handlebar Step Two Install Discharge Chute Remove the gear cover from top of chute pedestal Step Three Install Chute Control AssemblyStep Three Install Chute Control Assembly Step Four Install Discharge Chute Rod Step Four Install Discharge Chute Rod Step Five Install Remote Deflector Control Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources