Ariens 926042 quick start Step Four Install Discharge Chute Rod

Page 6

Step Four:

Install Discharge Chute Rod

NOTE: To ensure the discharge chute follows its full range of travel, make sure the control lever is centered in the slot and pointing straight up before installing the chute rod.

1.Insert chute rod end without ears into control lever and slide into control panel until opposite end of rod clears the gear assembly.

2.Align end of chute rod with hex hole in gear assembly and insert until ears hit gear.

3.Insert hairpin into hole in chute rod near gear assembly.

Image 6

Contents Quick Start Guide Step One Unfold Handlebar Step Two Install Discharge Chute Step Three Install Chute Control Assembly Remove the gear cover from top of chute pedestalStep Three Install Chute Control Assembly Step Four Install Discharge Chute Rod Step Four Install Discharge Chute Rod Step Five Install Remote Deflector Control Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources