Ariens 926042 quick start Step Five Install Remote Deflector Control Cable

Page 8

Step Five: Install Remote

Deflector Control Cable

1.Connect the barrel cable end to the chute deflector cable anchor before clipping the cable to the discharge chute cable bracket.

2.Route deflector remote cable along the left side of the chute pedestal.

3.Insert the barrel on the cable end into the bracket on left side of chute deflector.

4.Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket.

5.Push the seal securely over the end on the cable fitting to prevent water from entering the cable.

6.Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary (see Remote Deflector Control in Owners Manual.

Image 8

Contents Quick Start Guide Step One Unfold Handlebar Step Two Install Discharge Chute Step Three Install Chute Control Assembly Remove the gear cover from top of chute pedestalStep Three Install Chute Control Assembly Step Four Install Discharge Chute Rod Step Four Install Discharge Chute Rod Step Five Install Remote Deflector Control Cable Step Six Check Function of Dual Handle Interlock Step Seven Check Track Tension Step Eight Adjust Skid Shoes Step Nine Check Auger Gearcase Oil Step Ten Check Engine Crankcase Oil Step Eleven Fill Engine Fuel Tank Step Twelve Starting the Engine Starting Engine / Step a Throttle Starting Engine / Step B Fuel Valve Starting Engine / Step C Key Starting Engine / Step D Choke Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Starting Engine / Step G Electric Start Starting Engine / Step H Warm up Step Thirteen Stopping the Engine Additional Resources