7" XL TWO-PIECE WRAP AROUND COVER
AND PEDESTAL
1 - Insert the logo into the cover.
7” XL
WRAP
AROUND COVER
LOGO
TOP
COVER
2 - Slide the outside cover into position and align the hole in the cover with the cage nut attached to the top plate. Secure using the
3 - Insert the back of the top cover onto the back of ledges. and securely snap the top cover into the hole in the front of the out side cover.
4 - Align the holes on the side of the bottom wrap with the holes on the top of the vertical. Secure the cover using the #12 x 1/2” screws provided.
STAINLESS STEEL
2 SCREW
1
OUTSIDE
COVER
3
4
#12X1/2” SCREW 1 ON EACH SIDE
If your pool vertical does not have holes, simply use the cover or the pedestal as a template and drill through
WRAP AROUND PEDESTAL the vertical using a 9/64" diameter drill bit, being careful not to damage the pool wall.
1 - Insert the logo into the pedestal.
2 - Place the pedestal onto the bottom of the vertical and align the holes on the side of the wrap with the holes on the bottom of the vertical.
3 - Secure the pedestal using the #12 x 1/2” screws provided.
1 | 2 | 3 |
#12X1/2” SCREW 1 ON EACH SIDE
27