Intel 1000SX, 1000LX manual Server

Page 20

C H A P T E R 3 Configure the module and connect the cables

4Repeat steps 1 through 3 for the second 1000Base Module. Connect to a permissible vacant port (either 2 or 3).

4	5	6
		Module
		Status
	Matrix Module for 500 Series Switches

1

2

3

Link

Status

Internal Port

	1000SX Module for 500 Series Switches
	CLASS 1 LASER PRODUCT
1000Base-SX	Stack Interface Module

	1000SX Module for 500 Series Switches
	CLASS 1 LASER PRODUCT
1000Base-SX	Stack Interface Module

Server

5Plug the SC connectors on the ﬁber optic cables into the RX and TX sockets, and connect the other end of the cables to a device or group of switches.

6Check the LEDs on the 1000Base Modules to verify the links. For more information on LEDs, see Chapter 2

17

Image 20

Contents 1000SX Module and 1000LX Module For 500 Series Switches 1000SX Module and 1000LX Module For 500 Series Switches User GuideFirst edition October 715236-001 Quick Start Class Laser ProductExpress 500 Series Switch Turn on the switch A P T E R 1 Quick Start 1000SX and 1000LX Modules Introduction Front panel of the 1000SX Module is shown belowModule LEDs Page Conﬁgure the module and connect the cables Conﬁguring the Module Stand-alone Mode Cabling the ModuleStack Mode Server A P T E R 3 Configure the module and connect the cables Link Aggregation with Two Modules Cabling to a Matrix Server Page Weight approximate SpeciﬁcationsMMF Limited Hardware Warranty Limited Hardware WarrantyLimited Hardware Warranty Europe only Limited Hardware Warranty Federal Communications Commission FCC Statement Avertissement Avvertenza Automated Support Customer Support Technicians

Related manuals

Manual 18 pages 60.84 Kb

Manual 45 pages 47.35 Kb