Intel 1000SX, 1000LX manual Cabling the Module, Stand-alone Mode

CH A P T E R 3 Configure the module and connect the cables

	Cabling the Module
Introduction	The cable connections to the module depend on the mode in which
	the module is to be used.
	Stand-alone Mode
Cabling for a single switch	Follow these instructions to provide a high-speed (1000Base-SX/
	1000Base-LX) link between the switch containing the 1000Base
	Module and another switch, device or group of switches:
	Warning When used in stand-alone mode, this module must not
	be installed in a switch containing a Stack Interface
	Module, a Matrix Module or a 1000Base Module set in
	stack mode.
	1 Plug the SC connectors on the optic fiber cable into the RX and
	TX sockets on the 1000Base-SX/1000Base-LX connector.
	1000SX Module for 500 Series Switches
	CLASS 1 LASER PRODUCT
	1000Base-SX	Stack Interface Module
		1716

2Plug the other end of the cable into a device and check the LEDs on the 1000Base Module to verify the link. For informa- tion on the LEDs, see Chapter 2.

11