Intel 1000SX manual Click 802.1Q Map

Page 27

C H A P T E R 4 Configure the module

Mapping the VLANs

New VLANs should be mapped when they are created. Creating new VLANs is described in the user guide for the switch. The following in- structions enable you to map existing VLANs using Intel Device View.

1Select VLAN/Routing Setup (for 550 switches) or VLAN Setup (for 510 and 520 switches).

Any VLANs detected and their mapped status are displayed.

2 Click 802.1Q Map....

24

Image 27

Contents For1000SX500SeriesAdvancedSwitchesModule User Guide 1000SX Advanced Module for 500 Series SwitchesFirst edition October Quick Start Installing the moduleTurn off the switch Turn on the switch 3101 Introduction Getting to know the ModuleFront panel of the 1000SX Advanced Module is shown below Installing the moduleIeee 802.1 Q VLANs via this module VLANs Proprietary 500 series VLANsModule LEDs A P T E R 2 Getting to know the Module Cabling the module Cable the moduleStand-alone Mode Stack Mode Stacking Cable Connected to Matrix Module Primary Secondary Combine bandwidth on two modules Cabling to a Matrix Module Server Configure the module Configuring the module Combining port bandwidth of two modules A P T E R 4 Configure the module Map VLANs to Ieee 802.1 Q VLANs Click 802.1Q Map A P T E R 4 Configure the module A P T E R 4 Configure the module Specifications 50 ∝m MMF ConnectorFiber type Modal bandwidth @ 850nm 62.5 ∝m MMFPerformance specifications are A P T E R 5 Specifications Limited Hardware Warranty See RMA information under Limited Limited Hardware Warranty Europe only Returning a Defective Product RMA Translation Federal Communications Commission FCC StatementManufacturer Declaration Avertissement Avvertenza P E N D I X a P E N D I X a Automated Support Customer Support TechniciansNorth America only 916 Country Number Language

Related manuals

Manual 18 pages 60.84 Kb

Manual 30 pages 17.35 Kb