Intel 1000SX manual Configuring the module

Page 23

CH A P T E R 4 Configure the module

Configuring the module

To change the module mode using Intel Device View

The default settings for the Module Mode is Stack Mode and 802.1Q VLAN tagging disabled. With the switch containing the 1000SX Ad- vanced Module displayed in the Device View window:

Warning Changing mode causes Intel Device View to save the switch configuration and reset the switch.

1Right-click the 1000Base-SX port on the module and select Port Setup.

2Click the Module tab.

3Select the correct modes.

Note When 802.1 Q tagging is disabled, tagged frames received on all ports are forwarded without recogniz- ing the tag. When 802.1 Q is enabled, only tagged frames received on the module’s 1000Base port are recognized. Tagged frames received on the front ports of the switch are discarded.

4Click OK. The configuration is saved and the switch reset.

20

Image 23

Contents For1000SX500SeriesAdvancedSwitchesModule User Guide 1000SX Advanced Module for 500 Series SwitchesFirst edition October Quick Start Installing the moduleTurn off the switch Turn on the switch 3101 Introduction Getting to know the ModuleFront panel of the 1000SX Advanced Module is shown below Installing the moduleIeee 802.1 Q VLANs via this module VLANs Proprietary 500 series VLANsModule LEDs A P T E R 2 Getting to know the Module Cabling the module Cable the moduleStand-alone Mode Stack Mode Stacking Cable Connected to Matrix Module Primary Secondary Combine bandwidth on two modules Cabling to a Matrix Module Server Configure the module Configuring the module Combining port bandwidth of two modules A P T E R 4 Configure the module Map VLANs to Ieee 802.1 Q VLANs Click 802.1Q Map A P T E R 4 Configure the module A P T E R 4 Configure the module Specifications 50 ∝m MMF ConnectorFiber type Modal bandwidth @ 850nm 62.5 ∝m MMFPerformance specifications are A P T E R 5 Specifications Limited Hardware Warranty See RMA information under Limited Limited Hardware Warranty Europe only Returning a Defective Product RMA Translation Federal Communications Commission FCC StatementManufacturer Declaration Avertissement Avvertenza P E N D I X a P E N D I X a North America only 916 Country Number Language Automated SupportCustomer Support Technicians

Related manuals

Manual 18 pages 60.84 Kb

Manual 30 pages 17.35 Kb