Intel 1000SX manual Manufacturer Declaration

Page 39

A P P E N D I X A

Manufacturer Declaration

Intel declares that the Express 500 Series Switches comply with the EU Directive 89/336/EEC, using the EMC standards EN55022 and EN55024. These products also meet EU Directives 74/23/EEC and 93/ 68/ and are certified by DEMKO to be compliant with EN 60950/A1/ A2/A3/A4/A11 and by UL to be compliant with UL 1950 and CSA - C22.2 No. 950. These products have been tested and verified to meet CISPR 22 Class A requirements and are registered with VCCI Class A products.

WARNING: Fiber-optic ports on 1000SX Advanced—Optical Safety

CLASS 1

LASER PRODUCT

For optical safety, never look directly at, or use optical instruments on, the fiber TX laser port and fiber cable ends when they are powered-up. The module’s optical ports must be terminated either with an optical connector or a dust plug.

WARNING

The system is designed to operate in a typical office environment. Choose a site that is:

•Clean and free of airborne particles (other than normal room dust).

•Well ventilated and away from sources of heat including direct sun- light.

•Away from sources of vibration or physical shock.

•Isolated from strong electromagnetic fields produced by electrical devices.

•In regions that are susceptible to electrical storms, we recommend you plug your system into a surge suppressor and disconnect tele- communication lines to your modem during an electrical storm.

•Provided with a properly grounded wall outlet.

Do not attempt to modify or use the supplied AC power cord if it is not the exact type required.

Ensure that the system is disconnected from its power source and from all telecommunications links, networks, or modems lines whenever the chassis cover is to be removed. Do not operate the system with the cover removed.

36

Page 38 Page 40
Image 39
Page 38 Page 40
Contents For1000SX500SeriesAdvancedSwitchesModule User Guide 1000SX Advanced Module for 500 Series SwitchesFirst edition October Quick Start Installing the moduleTurn off the switch Turn on the switch 3101 Introduction Getting to know the ModuleFront panel of the 1000SX Advanced Module is shown below Installing the moduleIeee 802.1 Q VLANs via this module VLANs Proprietary 500 series VLANsModule LEDs A P T E R 2 Getting to know the Module Cabling the module Cable the moduleStand-alone Mode Stack Mode Stacking Cable Connected to Matrix Module Primary Secondary Combine bandwidth on two modules Cabling to a Matrix Module Server Configure the module Configuring the module Combining port bandwidth of two modules A P T E R 4 Configure the module Map VLANs to Ieee 802.1 Q VLANs Click 802.1Q Map A P T E R 4 Configure the module A P T E R 4 Configure the module Specifications 50 ∝m MMF ConnectorFiber type Modal bandwidth @ 850nm 62.5 ∝m MMFPerformance specifications are A P T E R 5 Specifications Limited Hardware Warranty See RMA information under Limited Limited Hardware Warranty Europe only Returning a Defective Product RMA Translation Federal Communications Commission FCC StatementManufacturer Declaration Avertissement Avvertenza P E N D I X a P E N D I X a Automated Support Customer Support TechniciansNorth America only 916 Country Number Language
Related manuals
Manual 18 pages 60.84 Kb Manual 30 pages 17.35 Kb
Top Page Image Contents