MPCBL0010 SBC—Operating the Unit
4.Simultaneously push both handles in again and rotate until the handles are at their farthest point of travel. Repeat this process until the SBC faceplate is clear of the chassis. At this point the SBC can be removed from the chassis.
3.5AdvancedMC Module Installation and Extraction
To install or remove an AdvancedMC* module into the MPCBL0010 SBC, simply move the SBC handle from the vertical to the horizontal position. This will move the handle out of the way of the AdvancedMC slot and allow modules to be inserted or removed.
Note: Do not push the SBC handle inward because this will activate the Hot Swap switch.
Refer to the AdvancedMC manufacturer user manual for other considerations specific to the AdvancedMC module you are using.
3.6BIOS Configuration
In most cases, the BIOS defaults will provide the correct configuration to use the board. See Chapter 7.0, “BIOS Setup” for a complete list of BIOS options.
3.7Remote Access Configuration
Console redirection to the serial port is enabled by default. This setting will redirect the text output of the BIOS and operating system to the
3.8Software Updates
It is important to use compatible BIOS, FPGA, and IPMC firmware versions. Since all the software and hardware versions are exchanging specific information, they must be in synch. Always follow the documentation instructions included with the software updates.
Intel NetStructure® MPCBL0010 Single Board Computer |
|
Technical Product Specification | October 2006 |
32 | Order Number: 304120 |