ViewSonic PJ452 manual Image menu, Normal, Over Scan, Position, Phase

IMAGE menu

With the IMAGE menu, items shown in the table below can be performed.

Choose an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress. Then perform it referring to the following table.

Item		Description
ASPECT	Using the buttons ▲/▼ switches the mode for aspect ratio.
	At a RGB signal
	4:3	16:9 NORMAL
		═════════
	At a video signal / no signal
	4:3	16:9
		═══
	• The NORMAL mode keeps the original aspect ratio of the
	signal.
	• At a HDTV component video signal of 1125i (1080i) or 750p
	(720p), this item can’t be chosen.
	• Performing the automatic adjustment initializes the aspect
	ratio setting.
OVER SCAN	Using the buttons ▲/▼ adjusts the over-scan ratio.
	Large (It reduces picture) Small (It magnifies picture)
	• This item can be chosen only at a video signal.
	• When this adjustment is too large, certain degradation may
	appear at the frame area of the picture. In such a case, please
	adjust small.
V POSITION	Using the buttons ▲/▼ adjusts the vertical position.
	Up ↔ Down
H POSITION	Using the buttons ▲/▼ adjusts the horizontal position.
	Left ↔ Right
H PHASE	Using the buttons ▲/▼ adjusts the horizontal phase to
	eliminate flicker.
	Right ↔ Left
	• This item can be chosen only at a RGB signal or a component
	video signal (except 525i (480i) and 625i (576i)).

ViewSonic PJ452 30