ViewSonic 300 manual Operations, Power on, Power OFF, Standby

Page 11

OPERATIONS

 

STANDBY/

STANDBY/ON Button

ON Button

POWER Indicator

ZOOM Knob

FOCUS Ring

Power Switch

Lens cap

Power ON

1Check if the power cord is connected correctly.

2Set the power switch to [I]. When the standby mode is selected, the POWER indicator is orange.

3Press the STANDBY/ON button on the control panel or the remote control device. The warm-up starts and the POWER indicator blinks green.

4The POWER indicator stops blinking and turns green when the power is on. Remove the lens cap.

5Adjust picture size with the ZOOM button.

6Adjust focus with the FOCUS button.

Power OFF

1Press the STANDBY/ON button on the control panel or the remote control device. Then the message "Power off?" will appear on the screen, and the message will disappear by any operation or if no operation is carried out for 5 seconds. During this message indication, press the STANDBY/ON button again. The projector lamp is turned off and the lamp will be cooled down. The POWER indicator blinks orange when the lamp cools down. Pressing the STANDBY/ON button has no effect while the POWER indicator is blinking.

2The system goes into the Standby mode after cooling and the POWER indicator stops blinking and changes to orange. Check if the indicator is orange and set the power switch to [0].

3The POWER indicator is extinguished when power is off. Be sure to close the lens door.

WARNING: Before using this equipment, read this manual thoroughly. Always ensure that the equipment is used safely.

NOTE:

•Except in emergencies, follow the above-mentioned procedure for turning the power off. Any incorrect procedure will shorten the life of the projector lamp and LCD panel.

•To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a RS-232C cable is connected, turn on the computer before switching on the projector.

•If the projector continues projecting the same image, the image may remain as an after-image. Do not project the same image for a long time.

ViewSonic PJ750

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents PJ750 Contents For Your Records Electronic Warranty RegistrationBefore USE FeaturesContents of Package Part Names Button Remote Control Device refer to page 9, OperationsAttaching the handle Inserting the BatteriesAngle Adjustment InstallationInstallation of the Projector and Screen Audio in RGB CablingPlug & Play Power ConnectionExample of system setup Standby Power onPower OFF OperationsBasic Operation Menu Display Start/Stop Press the Menu button Volume Adjustment Press the VolumeSet / Clear Keystone Mode Press the Keystone Adjust Keystone PressSetup Menu RGB Automatic Adjustment at RGB Input Select the Execute withAutomatic Adjustment at Video Input Select the Execute with Input MenuSelect Blank Screen Color Select color with Setup Initial Screen Display Select Turn on withSelect Color Temperature Image MenuSelect Menu Display Language Select with Set / Clear Whisper Mode PressOptions Menu Select Menu Background Color Select the color with No Signal MenuSetup Initial Screen Display Select the Turn on with Clear Initial Screen Display Select the Turn OFF withLamp MaintenanceReplacing the Lamp Air Filters Other MaintenanceOSD Message TroubleshootingIndicator Message Symptom Specification Specifications= FAX Customer SupportViewsonic Projector Limited WarrantyAppendix Power Cord Safety GuidelinesUser Information for All Countries FCC InformationCompliance Information for Canada Compliance Information for European CountriesViewSonic Corporation
Top Page Image Contents