ViewSonic 300 manual Troubleshooting, OSD Message

Page 22

TROUBLESHOOTING

OSD Message

The messages as described below may appear on the screen at power ON. Take the appropriate mea- sures when such messages appear.

	Table 9: OSD Message
Message	Contents

CHANGE THE LAMP	The usage time of lamp will be reaching 2000 hr shortly (*2).
AFTER REPLACING LAMP,	It is recommended to replace the lamp soon. Prepare a new
RESET THE LAMP TIME.	lamp as replacement.
(*1)

CHANGE THE LAMP	The usage time of lamp will be reaching 2000 hr shortly.
AFTER REPLACING LAMP,	It is recommended to replace the lamp within * * hours (*2).
RESET THE LAMP TIME.	It might happen that the lamp is cut off before * * hr by any
THE POWER WILL TURN OFF	chance. Power will be switched OFF automatically in * *
AFTER **hr.	hours. Replace the lamp as shown on p. 17-18, “Lamp.”
(*1)	Always reset the lamp timer after replacing the lamp.

CHANGE THE LAMP	The usage time of lamp is about to reach. Power will be
AFTER REPLACING LAMP,	switched OFF in a few minutes (*2).
RESET THE LAMP TIME.	Switch power OFF immediately and replace the lamp as
THE POWER WILL	shown on p. 17-18, “Lamp.” Always reset the lamp timer after
TURN OFF	replacing the lamp.
AFTER 0 hr.

NO INPUT IS DETECTED	No input signal found.
ON ***	Check the signal input connections and signal sources.

	The horizontal or vertical frequency of the input signal is not
SYNC IS OUT OF RANGE	within the specified range.
ON ***	Check the specifications of the equipment and the signal
	source.

NOTE:

(*1) This message is cleared automatically after approximately three minutes, and appears every time power is switched ON.

(*2) The unit has a function to turn the power off which will be active when the usage time reaches 2000 hr. However the life of lamp might be much different among lamps, so that it might happen that a lamp is cut off before the function is active.

20 ViewSonic PJ750

Image 22

Contents PJ750 Contents Electronic Warranty Registration For Your RecordsContents of Package FeaturesBefore USE Part Names Remote Control Device refer to page 9, Operations ButtonInserting the Batteries Attaching the handleInstallation of the Projector and Screen InstallationAngle Adjustment Cabling Audio in RGBExample of system setup Power ConnectionPlug & Play Operations Power onPower OFF StandbyBasic Operation Adjust Keystone Press Volume Adjustment Press the VolumeSet / Clear Keystone Mode Press the Keystone Menu Display Start/Stop Press the Menu buttonSetup Menu Input Menu Automatic Adjustment at RGB Input Select the Execute withAutomatic Adjustment at Video Input Select the Execute with RGBImage Menu Setup Initial Screen Display Select Turn on withSelect Color Temperature Select Blank Screen Color Select color withOptions Menu Set / Clear Whisper Mode PressSelect Menu Display Language Select with Clear Initial Screen Display Select the Turn OFF with No Signal MenuSetup Initial Screen Display Select the Turn on with Select Menu Background Color Select the color withMaintenance LampReplacing the Lamp Other Maintenance Air FiltersTroubleshooting OSD MessageIndicator Message Symptom Specifications SpecificationCustomer Support = FAXLimited Warranty Viewsonic ProjectorPower Cord Safety Guidelines AppendixCompliance Information for European Countries FCC InformationCompliance Information for Canada User Information for All CountriesViewSonic Corporation