No Signal Menu
The same adjustments and settings are available as with the Image and Options menus when the MENU button is pressed during display of the “NO INPUT IS DETECTED ON***”or “SYNC IS OUT OF RANGE ON***”message while no signal is received. Select an item with the 
and 
buttons, and start or stop the operation with the
and 
buttons.
|
| Table 8: No Signal Menu |
|
|
| |
Item |
| Description |
|
|
| |
|
|
|
|
|
| |
| Reduce | Increase |
|
|
| |
| • When this function is used, audio input is automatically switched to video. The | |||||
VOLUME | audio input can be switched by moving the DISK PAD left and right during the | |||||
| display of the volume adjustment bar. The volume adjustment bar is displayed by | |||||
| pressing VOLUME | button. |
|
|
| |
|
|
|
| |||
| Select Blank Screen Color: Select the color with the |
| button. | |||
BLANK | • When the blank mode is set with BLANK ON, without a signal, or with a non- | |||||
standard signal, the image is cleared and the complete screen is displayed in the | ||||||
| ||||||
| selected color. |
|
|
|
| |
|
|
| ||||
MIRROR | Select Mirror Status: Select the mirror status with the | button. | ||||
| Setup Initial Screen Display: Select the TURN ON with the | button. | ||||
START UP | Clear Initial Screen Display: Select the TURN OFF with the | button. | ||||
• Note that if TURN OFF is selected the blank screen is displayed in blue when | ||||||
| ||||||
| there is no signal. |
|
|
|
| |
|
|
| ||||
MENU COLOR | Select Menu Background Color: Select the color with the | buttons. | ||||
LANGUAGE | Select Menu Display Language: Select the language with the | buttons. | ||||
| Set AUTO OFF: Set | buttons. The system | ||||
| automatically enters the standby mode when a signal is not detected for the set | |||||
AUTO OFF | time. |
|
|
|
| |
Clear AUTO OFF: Select the STOP (0 min.) with the | button. When the STOP | |||||
| ||||||
| is selected the system does not enter the standby mode even if no signal is | |||||
| received. |
|
|
|
| |
|
|
|
| |||
| SYNC ON G Valid: Select the TURN ON with the | button. |
| |||
| SYNC ON G Invalid: Select the TURN OFF with the | button. |
| |||
SYNC ON G | • May not be displayed correctly with some input signals when the SYNC ON G is | |||||
| valid. In such cases, remove the signal connector so that no signal is received, | |||||
| set the SYNC ON G to invalid, and reconnect the signal. |
| ||||
|
|
| ||||
| Set / Clear WHISPER Mode: Press the | button. When WHISPER is | ||||
WHISPER | selected, the WHISPER mode is active. In the WHISPER mode, acoustic noise | |||||
| level from the unit is reduced, and brightness level on the screen is a little lower. | |||||
|
|
|
|
|
| |
16ViewSonic PJ750