Eiki LC-SD12 Lamp Replacement, Model No. of your projector, Replacement Lamp Type No, TOP Control

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp draws to an end, LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly.

This indicator lights yellow when the life of the projection lamp draws to an end.

TOP CONTROL

WARNING

POWERLAMP REPLACE

INPU

Allow the projector to cool, for at least 45 minutes before you open the Lamp Cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with the lamp assembly of the same type.

Do not drop the lamp assembly or touch the glass bulb. The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

1	Turn off the projector and disconnect the AC plug. Allow the
	projector to cool at least for 45 minutes.
2	To remove the lamp cover, remove the screw with a screwdriver .
3	Remove two screws with a screwdriver and pull out the lamp
	assembly by grasping the handle.
4	Replace the lamp assembly with a new one and tighten the two
	screws back into the position. Make sure that the lamp
	assembly is set properly. Replace the lamp cover and tighten
	the screw.
5	Connect the AC Power Cord to the projector and turn on the
	projector.
6	Reset the Lamp Replace Counter.
	Refer to “Lamp Replace Counter” on the next page .	Screws

Note :

–Do not reset the Lamp Replace Counter when the projection lamp has not been replaced.

Screw

Lamp Cover

Handle

Lamp Assembly

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

•	Model No. of your projector	:	LC-SD12
•	Replacement Lamp Type No.	:	POA-LMP57
			(Service Parts No. 610 308 3117)

42