Eiki lc-sb15 owner manual Remote Control Operating Range, Remote Control Batteries Installation

Page 15

Part Names and Functions

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum operating range for the remote control is about 16.4’ (5m) and 60° in front of the projector.

16.4’ (5 m)

60°

Remote Control Batteries Installation

Remove the battery

1compartment lid.

Press the lid down- ward and slide it.

2

Slide the batteries into

3

Replace the compartment

the compartment.

lid.

Two AA size batteries For correct polarity (+ and

– ), be sure battery terminals are in contact with pins in compartment.

To insure safe operation, please observe the following precautions :

Use (2) AA, UM3 or R06 type alkaline batteries.

Replace two batteries at the same time.

Do not use a new battery with a used battery.

Avoid contact with water or liquid.

Do not expose the remote control to moisture, or heat.

Do not drop the remote control.

If a battery has leaked on remote control, carefully wipe case clean and install new batteries.

Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

15

Image 15
Contents Model LC-SB15 Table of Contents Risk of Electric Shock Do not Open To the OwnerVoor de klanten in Nederland Safety InstructionsMoving the Projector Safety InstructionsInstalling the Projector in Proper Position Air CirculationFederal Communication Commission Notice Compliance200 240 V AC ComplianceFor Continental Europe For the U.S.A. and CanadaFeatures and Design Bottom Part Names and FunctionsFront BackTerminal Part Names and FunctionsUi o TopSignal Emission indicator Remote ControlPointer Function Laser Pointer FunctionWireless Mouse Operation Remote Control CodeRemote Control Batteries Installation Remote Control Operating RangeInstallation Adjustable FeetPositioning the Projector Connecting to a Computer InstallationConnecting to Video Equipment TerminalsProjector Basic Operation Turning On the ProjectorTurning Off the Projector Basic Operation Zoom AdjustmentFocus Adjustment Keystone AdjustmentDirect Operation Timer FunctionSound Adjustment No Show FunctionOn-Screen Menu Remote ControlOn-Screen Menu Top ControlMenu Bar Computer Input Input Source SelectionRGB Mode Computer InputComputer System Selection AutoAuto PC Adj Computer Adjustment AutoPC Adjust Menu To store adjustment dataComputer Adjustment Manual To clear adjustment data ResetMode free Display area To store adjustment dataImage Level Selection Image Level Adjustment Screen Size Adjustment Source Select Menu Video Video InputInput Source Selection Video, S-Video Input button Video Computer Video button VideoRGB Scart Video InputInput Source Selection Component, RGB Scart 21-Pin ComponentAV System Menu Video or S-Video Video System SelectionVideo or S-Video AutoImage button Standard Cinema CinemaColor TintProgressive Resets all adjustment to their previous figure Setting SettingSetting To change the code for the projector To change the code for the remote controlThen check the items below Maintenance and CleaningProjector is shut down and the Warning indicator lights red TOP ControlCleaning the Projector Cabinet Maintenance and CleaningCleaning the Air Filters Cleaning the Projection LensReset the Lamp replace counter Lamp ReplacementLamp Replace Counter When the lamp replace counter is reset, the LampAppendix TroubleshootingAppendix Projector is OFF. The AC power cord is unplugged Indicators and Projector ConditionInput PC AdjustImage Select Image Adjust Screen Menu TreeSound Setting Image Adjust ScreenImage Select KHz Compatible Computer SpecificationsResolution FreqTechnical Specifications DVI-I Terminal DIGITAL/ANALOG Configurations of TerminalsTerminal HDB15-PIN Pin Configuration Terminal DVI-I Pin ConfigurationKA-DV20 Service Port ConnectorOptional Parts POA-MACAPAttaching the Lens Cover Page Key to better communications Canada