Eiki LC-VC1 owner manual Wired Remote Control Operations

Page 17

WIRED REMOTE CONTROL

OPERATIONS

When using this Remote Control Unit as Wired Remote Control, Connect Remote Control Unit to R/C JACK with Remote Control Cable (supplied). Batteries installation is required when using as Wired Remote Control Unit.

REMOTE CONTROL BATTERIES INSTALLATION

1. Remove the battery compartment 2 Slide 2 batteries into the compartment. 3 Replace the compartment lid. lid

To insure safe operation, please observe the following precautions: •Use (2) AA, UM3 or R06 type alkaline batteries.

•Replace two batteries at the same time.

•Do not use a new battery with a used battery. •Avoid contact with water or liquid.

•Do not expose Remote Control Unit to moisture, or heat •Do not drop Remote Control Unit.

•If batteries have leaked on Remote Control Unit, carefully wipe the case clean and load new batteries..

Image 17

Contents Model LC-VC1 To the Owner Safety Instructions Compliances Table of Contents Digital Zoom function magnifies the image up to IBM-compatible and Macintosh computers up toPage Preparation Connecting AC Power Cord Recommendation Positioning the ProjectorMoving Projector Adjustable FeetPage Cables used for connection * = Cables are not Speaker Cable Mini Plug stereo Page TOP Control Operating Range Remote Control Unit can be used as either Wired or WirelessWired Remote Control Operations Screen Menu Operation below HOW to Operate ON-SCREEN MenuPress Menu button to display ON-SCREEN Menu Move Pointer red frame to Menu Icon that youPress Menu Button for PC input source Menu BARTurning on Projector Disconnect AC Power CordTurning OFF the Projector Projector againFocus Adjustment Zoom AdjustmentLens Shift Adjustment Keystone AdjustmentPicture Freeze Function Mute SettingNo Show Function Direct Operation When projector cannot recognize connected signal asPC ADJ. button on Top Control or on Remote Control Unit Auto PC AdjustmentMenu above. Refer to of Manual PC Adjustment section P26 Select Computer System ManuallyNumber of total dots in one horizontal period. Press Point Manual PC AdjustmentWhenever you use it To store adjustment parameters, move a red frame pointer to Compatible Computer Specifications Press Menu button and ON-SCREEN Menu will appear. Press Image Level Select DirectImage Level Select Menu Better balance of contrast. From 0 to Image Level AdjustmentTo compress the image size, press the D.ZOOM V button. Expand functionSource through Menu Operation see below Projector automatically detects incoming Video system Video JACK, YIC Jacks or S-VIDEO JackImage Level Select Direct Video Mode Set On to provide progressive scan mode Progressive cannot be selected when 480p, 575p orColor. From 0 to Set On to reduce noise rough parts of the imageProvides image at the normal video aspect ratio of 4 Aspect ratio at wide video aspect ratio of 16On Screen Menu Power off? messagePress both Menu and Normal buttons on the Remote Control To change the code of the Remote ControlCleaning the Projection Lens AIR Filter Care and CleaningMake sure that Lamp Assembly is set properly. Replace Lamp Lamp ReplacementConnect AC Power Cord to projector and turn on projector Lamp Replace CounterPage Page Specifications are subject to change without notice RGB Terminal Configurations of TerminalsEiki Czech SPOL. S.R.O