Eiki LC-VC1 owner manual

Page 40

Before calling your dealer or service center for assistance, check the matters below once again.

1.Make sure you have connected projector to your equipment as described in the section “CONNECTING THE PROJECTOR” on pages

1113.

2.Check cable connection. Verify that all computer, video and power cords are properly connected.

3.Verify that all power is switched on.

4.If projector still does not produce an image, re-start the computer.

5.If the image sill does not appear, unplug projector from the computer and check the computer monitor’s display. The problem may be with your graphics controller rather than with projector. (When you reconnect projector, remember to turn the computer and monitor off before you power up projector. Power the equipment back on in order of projector and computer.)

6.If the problem still exists, check the following chart.

Image 40

Contents Model LC-VC1 To the Owner Safety Instructions Compliances Table of Contents IBM-compatible and Macintosh computers up to Digital Zoom function magnifies the image up toPage Preparation Connecting AC Power Cord Positioning the Projector RecommendationAdjustable Feet Moving ProjectorPage Cables used for connection * = Cables are not Speaker Cable Mini Plug stereo Page TOP Control Remote Control Unit can be used as either Wired or Wireless Operating RangeWired Remote Control Operations HOW to Operate ON-SCREEN Menu Screen Menu Operation belowPress Menu button to display ON-SCREEN Menu Move Pointer red frame to Menu Icon that youMenu BAR Press Menu Button for PC input sourceDisconnect AC Power Cord Turning on ProjectorTurning OFF the Projector Projector againZoom Adjustment Focus AdjustmentLens Shift Adjustment Keystone AdjustmentNo Show Function Mute SettingPicture Freeze Function When projector cannot recognize connected signal as Direct OperationAuto PC Adjustment PC ADJ. button on Top Control or on Remote Control UnitMenu above. Refer to of Manual PC Adjustment section P26 Select Computer System ManuallyWhenever you use it Manual PC AdjustmentNumber of total dots in one horizontal period. Press Point To store adjustment parameters, move a red frame pointer to Compatible Computer Specifications Image Level Select Menu Image Level Select DirectPress Menu button and ON-SCREEN Menu will appear. Press Image Level Adjustment Better balance of contrast. From 0 toExpand function To compress the image size, press the D.ZOOM V button.Source through Menu Operation see below Video JACK, YIC Jacks or S-VIDEO Jack Projector automatically detects incoming Video systemImage Level Select Direct Video Mode Progressive cannot be selected when 480p, 575p or Set On to provide progressive scan modeColor. From 0 to Set On to reduce noise rough parts of the imageAspect ratio at wide video aspect ratio of 16 Provides image at the normal video aspect ratio of 4Power off? message On Screen MenuTo change the code of the Remote Control Press both Menu and Normal buttons on the Remote ControlAIR Filter Care and Cleaning Cleaning the Projection LensLamp Replacement Make sure that Lamp Assembly is set properly. Replace LampConnect AC Power Cord to projector and turn on projector Lamp Replace CounterPage Page Specifications are subject to change without notice Configurations of Terminals RGB TerminalEiki Czech SPOL. S.R.O