Eiki LC-VC1 owner manual Direct Operation, When projector cannot recognize connected signal as

DIRECT OPERATION

Choose either Input 1 or Input 2 by pressing INPUT button on Top

Control or on Remote Control Unit.

MENU OPERATION

Press MENU button and ON-SCREEN MENU will appear. Press

POINT LEFT/RIGHT button to move a red frame pointer to

INPUT Menu icon.

2 Press POINT DOWN button to move a red arrow pointer to either Input 1 or Input 2 that you want to choose and then press SELECT button. When choosing Input 2, Source Select Menu will appear. Move POINTER to RGB and then press SELECT button. (Input 2 accepts R, G, B, HN and V computer signals (P 13).)

This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to “COMPATIBLE COMPUTER SPECIFICATION” on page 27). When selecting Computer, this projector automatically tunes to incoming signal and projects proper image without any special setting. (Some computers need setting manually.)

Note: Proiector may display one of the foIIowin~ messanes.

When projector cannot recognize connected signal as

PC system provided in this projector, Auto PC Adjustment

function operates to adjust projector and the message “AUTO PC Adj.” is displayed on SYSTEM icon. When image is not provided properly, manual adjustment is required. (Refer to P25 and 26.)

There is no signal input from computer. Make sure the connection of computer and projector is set correctly. (Refer to TROUBLESHOOTING on page 40.)

When projector cannot recognize connected signal as PC system provided in this projector, Auto PC

Adjustment function operates to adjust projector and the message “AUTO PC Adj.” Is displayed on SYSTEM icon. When image is not provided properly, manual adjustment is required (Refer to P25 and 26).

There is no signal input from computer. Make sure the connection of computer and projector is set

correctly,

(Refer to TROUBLESHOOTING on page 40.)