Eiki LC-VC1 owner manual Compliances

Page 4

COMPLIANCES

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

AC POWER CORD REQUIREMENT

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.

AC Power Cord for the United States and Canada:

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL) and certified by the Canadian Standard Association (CSA).

AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert the plug into the outlet, contact your electrician.

THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIOPMENT AND EASILY ACCESSIBLE.

Image 4

Contents Model LC-VC1 To the Owner Safety Instructions Compliances Table of Contents IBM-compatible and Macintosh computers up to Digital Zoom function magnifies the image up toPage Preparation Connecting AC Power Cord Positioning the Projector RecommendationAdjustable Feet Moving ProjectorPage Cables used for connection * = Cables are not Speaker Cable Mini Plug stereo Page TOP Control Remote Control Unit can be used as either Wired or Wireless Operating RangeWired Remote Control Operations HOW to Operate ON-SCREEN Menu Screen Menu Operation belowPress Menu button to display ON-SCREEN Menu Move Pointer red frame to Menu Icon that youMenu BAR Press Menu Button for PC input sourceDisconnect AC Power Cord Turning on ProjectorTurning OFF the Projector Projector againZoom Adjustment Focus AdjustmentLens Shift Adjustment Keystone AdjustmentNo Show Function Mute SettingPicture Freeze Function When projector cannot recognize connected signal as Direct OperationAuto PC Adjustment PC ADJ. button on Top Control or on Remote Control UnitMenu above. Refer to of Manual PC Adjustment section P26 Select Computer System ManuallyWhenever you use it Manual PC AdjustmentNumber of total dots in one horizontal period. Press Point To store adjustment parameters, move a red frame pointer to Compatible Computer Specifications Image Level Select Menu Image Level Select DirectPress Menu button and ON-SCREEN Menu will appear. Press Image Level Adjustment Better balance of contrast. From 0 toExpand function To compress the image size, press the D.ZOOM V button.Source through Menu Operation see below Video JACK, YIC Jacks or S-VIDEO Jack Projector automatically detects incoming Video systemImage Level Select Direct Video Mode Progressive cannot be selected when 480p, 575p or Set On to provide progressive scan modeColor. From 0 to Set On to reduce noise rough parts of the imageAspect ratio at wide video aspect ratio of 16 Provides image at the normal video aspect ratio of 4Power off? message On Screen MenuTo change the code of the Remote Control Press both Menu and Normal buttons on the Remote ControlAIR Filter Care and Cleaning Cleaning the Projection LensLamp Replacement Make sure that Lamp Assembly is set properly. Replace LampConnect AC Power Cord to projector and turn on projector Lamp Replace CounterPage Page Specifications are subject to change without notice Configurations of Terminals RGB TerminalEiki Czech SPOL. S.R.O