Intel BPC-500-5820 user manual Hardware Installation, Basic installation, Removing Top Cover

Page 7

Hardware Installation

Basic installation

1.CPU

2.Memory module

3.Hard Disk Drive

4.Wall-mount kit

Removing Top Cover

1.On the both sides, locate the two screws that secure the top cover to the chas- sis.

2.Use screw drvier to remove the top cover screws. Keep the screws safely for later use.

3.Pull the top cover slightly upward the main unit until the side tabs are disen- gaged from chassis.

4.If you feel it's hard to pull up the top cover, just loose the screws that secure the main unit on each side a little bit. Then, you may pull up the top cover easily.

BPC-500-5820 User's Manual

Image 7

Contents BPC-500-5820 Copyright All Rights Reserved FCC Class aTable of Contents Getting Started IntroductionDimension Mechanical & Environment Power AdapterRear Panel External I/OBasic installation Hardware InstallationRemoving Top Cover Installing CPU Installing Memory Module Installing Hard Disk Drive Installing Wall-Mount Bracket System Resources Box PC Kernel InformationAddress Ports Input/Output IONone Award Bios SetupStandard Cmos Setup 44M , 3.5Large Floppy Mode 3 SupportAuto Normal250 Bios Features SetupEnabled SetupPCI/VGA Palette Snoop Typematic Delay MsecVideo Bios Shadow Security OptionQWs Chipset Features Setup64MB Dram Opt RAS Precharge Sdram WR Retire RatePCI Peer Concurrency 15 Min Power Management SetupAlways On Poer OffHDD Off After Doze ModeStandby Mode Suspend ModeLevel PNP/PCI ConfigurationIntegrated Peripherals PIM-582 version Hardware MonitorIntegrated Peripherals PIM-582C version Parallel Port Mode IDE Burst ModeIDE HDD Block Mode IR ModeVisible Error Messages Audible Error MessagesPost Codes Hard disks diagnosis fail Keyboard error or no keyboard presentOverride enabled Defaults loaded Hard Disk initializing Please wait a momentCode Check Description of Check Post Code Error MessagesPage Page Procedure Howto Flash the Bios WarrantyWhat do you need