USB Keyboard Support
Choice enable, disable.
Init Display First
This item allows you to decide to active which bus first (PCI Slot or AGP first). The choice: PCI Slot, AGP.
VGA Shared Memory Size (PIM-582 only !)
Specify the size of system memory to allocate for video memory, from 1 MB to 8 MB. The choice: 1MB, 2MB, 4MB, 8MB.
POST Codes
During the
Audible Error Messages
Currently the only implemented beep code indicates that a video error has occurred and the BIOS cannot initialize the video screen to display any additional information. This beep code consists of a single long beep followed by two short beeps.
Visible Error Messages
BIOS ROM checksum error - System halted
The checksum of the BIOS code in the BIOS chip is incorrect, indicating the BIOS code may have become corrupt. Contact your system dealer to replace the BIOS.
CMOS battery failed
CMOS battery is no longer functional. Contact your system dealer for a replacement battery.
CMOS checksum error - Defaults loaded
Checksum of CMOS is incorrect, so the system loads the default equipment configuration. A checksum error may indicate that CMOS has become corrupt. This error may have been caused by a weak battery. Check the battery and replace if necessary.
CPU at nnnn
Displays the running speed of the CPU.
Display switch is set incorrectly
The display switch on the motherboard can be set to either monochrome or color. This message indicates the switch is set to a different setting than indicated in Setup. Determine which setting is correct, and then either turn off the system and change the jumper, or enter Setup and change the VIDEO selection.
Press ESC to skip memory test
The user may press Esc to skip the full memory test.
Floppy disk(s) fail
Cannot find or initialize the floppy drive controller or the drive. Make sure the controller is
25 |