Intel S845WD1-E manual Video Controller, Video Modes, 3D Mode Refresh Rate Hz

Page 37

Video Controller

The S845WD1-E server board provides an ATI Rage XL PCI graphics accelerator, along with

2 MB of video SDRAM and support circuitry for an embedded SVGA video subsystem. The ATI Rage XL chip contains a SVGA video controller, clock generator, 2D and 3D engine, and RAMDAC in a 272-pin PBGA. One 2Mx32 SDRAM chip provides 2 MB of video memory.

The SVGA subsystem supports a variety of modes, up to 1600 x 1200 resolution in 8/16/24/32 bpp modes under 2D, and up to 1024 x 768 resolution in 8/16/24/32 bpp modes under 3D. It also supports both CRT and LCD monitors up to 100 Hz vertical refresh rate.

The S845WD1-E server board provides a standard 15-pin VGA connector and supports disabling of the on-board video through the BIOS Setup menu or when a plug-in video card is installed in the AGP slot or any of the PCI slots.

Video Modes

The Rage XL chip supports all standard IBM VGA modes. The following table shows the 2D/3D modes supported for both CRT and LCD. The table specifies the minimum memory requirement for various display resolution, refresh rates, and color depths.

Table 11.

Video Modes

 

 

 

 

2D Mode

 

Refresh Rate (Hz)

S845WD1-E 2D Video Mode Support

 

 

8 bpp

16 bpp

24 bpp

32 bpp

640x480

 

60, 72, 75, 90, 100

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

800x600

 

60, 70, 75, 90, 100

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

1024x768

 

60, 72, 75, 90, 100

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

1280x1024

 

43, 60

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

1280x1024

 

70, 72

Supported

Supported

Supported

 

 

 

 

 

 

 

1600x1200

 

60, 66

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

1600x1200

 

76, 85

Supported

Supported

Supported

 

 

 

 

 

 

 

3D Mode

 

Refresh Rate (Hz)

S845WD1-E 3D

Video Mode Support with Z Buffer Enabled

640x480

 

60,72,75,90,100

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

800x600

 

60,70,75,90,100

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

1024x768

 

60,72,75,90,100

Supported

Supported

Supported

Supported

 

 

 

 

 

 

 

1280x1024

 

43,60,70,72

Supported

Supported

 

 

 

 

 

 

 

1600x1200

 

60,66,76,85

Supported

 

 

 

 

 

 

 

Description

37

Image 37
Contents Intel Server Board S845WD1-E Product Guide Disclaimer Contents Configuration Software and Utilities Server Board Installation and UpgradingSolving Bios Problems Tables Regulatory and Integration InformationContents Vii Viii Server Board Features Server Board FeaturesFeature Description Back Panel Connectors Back Panel ConnectorsHDD LED Front Panel ConnectorsServer Board Components Server Board Connector and Component LocationsProcessors Supported Memory ConfigurationsMemory Supported ProcessorsIntel 82845E Memory Controller Hub MCH Intel 845E ChipsetIntel 82801BA I/O Controller Hub ICH2 ControllerIntel 82802AB Firmware Hub FWH Serial Ports Hardware Management SubsystemParallel Port Diskette Drive ControllerHardware Management Asic Real-Time Clock, Cmos SRAM, and BatteryFan Monitoring Chassis Intrusion and DetectionLegacy USB Support IDE Support Scsi Hard Drive Activity LED ConnectorIDE Interfaces PCI IDE Support PCI Auto ConfigurationLanguage Support Bios UpdatesCustom Splash Screen Recovering Bios Data CD-ROM and Network Boot Boot OptionsBooting Without Attached Devices Intel Rapid Bios Boot Fast Booting Systems with Intel Rapid Bios BootSupervisor and User Password Functions Bios Security PasswordsSmbios System Management Bios SmbiosWake on LAN Technology Power Management FeaturesWake on Ring Resume on Ring AcpiEffects of Pressing the Power Switch System States and Power StatesPower States and Targeted System Power Wake-up Devices and Events Wake-up Devices and EventsHardware Support Fan Connectors Power ConnectorFan Connector Function/Operation Connector DescriptionInstantly Available PC Technology Location of the Standby Power Indicator LEDWake from PS/2 Devices Wake from USBPME# Wake-up Support PCI Bus Configuration IDs PCI Bus CharacteristicsPCI I/O Subsystem 32-bit, 33-MHz PCI SubsystemPCI Arbitration ATA-100Video Mode Support with Z Buffer Enabled 3D Mode Refresh Rate HzVideo Controller Video ModesNetwork Interface Controller NIC NIC Connector and Status LEDsVideo Memory Interface Hardware Monitoring Intel Server Board S845WD1-E Product Guide Before You Begin Tools and Supplies NeededEmissions Disclaimer Intel Server Board S845WD1-E Product Guide Installing DIMMs Dimm Installation GuidelinesMemory Dimm Socket Locations Removing DIMMsO Shield Dimensions Installing the I/O ShieldLocation of the Mounting Screw Holes Installing the Server BoardInstalling the Processor in the Processor Socket Installing a ProcessorAttaching the Fan Heat Sink Clips to the Processor Socket Removing the Processor Précaution Replacing the BatteryVaro Removing the Battery Connecting the IDE Cable Connecting the IDE CableJumper Settings for the Bios Setup Program Modes Setting the Bios Configuration JumperFunction/Mode Jumper Setting Configuration Preparing for the Update Updating the Bios with the Intel Express Bios Update UtilityRecording the Current Bios Settings Obtaining the Bios Update FileCreating Bootable Media Creating a Bios Update Media Creating a Bootable DisketteUpdating the Bios Recovering the Bios Bios Setup Program Modes Using the Setup ProgramBios Setup Program Function Keys Maintenance MenuMaintenance Menu Bios Setup Program Function Key DescriptionExtended Configuration Submenu Extended Configuration SubmenuUswc Main Menu Main MenuECC IoapicAdvanced Menu Advanced MenuPCI Configuration Submenu PCI Configuration SubmenuBoot Configuration Submenu Boot Configuration SubmenuPeripheral Configuration Submenu Peripheral Configuration SubmenuIRQ Default Auto defaultIRQ 7 default Enabled DefaultIDE Configuration Submenu IDE Configuration SubmenuCD-ROM Primary/Secondary IDE Master/Slave SubmenusDiskette Configuration Submenu Diskette Configuration SubmenuEvent Log Configuration Submenu Event Log Configuration SubmenuVideo Configuration Submenu Video Configuration SubmenuPCI Security Menu Security MenuPower Menu Power MenuAcpi Submenu Acpi SubmenuBoot Menu Boot MenuBoot Device Priority Submenu Boot Device Priority SubmenuAtapi CD-ROM Removable Devices Submenu Hard Disk Drives SubmenuHard Disk Drives Submenu Removable Devices SubmenuAtapi Cdrom Drives Submenu Exit MenuAtapi Cdrom Drives Submenu Exit MenuIntel Server Board S845WD1-E Product Guide Beep Codes Bios Beep CodesNumber of Beeps Description Bios Error Messages Bios Error MessagesError Message Explanation Nvram / Cmos / Password Intel Server Board S845WD1-E Product Guide U.S. and Canada Europe World Wide Web TelephoneAsia-Pacific region JapanIntel Server Board S845WD1-E Product Guide Baseboard Connectors Server Board ConnectorsPower and Hardware Control Connectors Add-in Board and Peripheral Interface Connectors Add-In Board and Peripheral Interface ConnectorsMemory Map Server Board ResourcesDMA Channels System Memory MapO Map MapAddress hex Size Description Interrupts InterruptsAddress hex Description Onboard mouse port if present, else user available Product Regulatory Compliance Product Safety ComplianceProduct EMC Compliance Product Regulatory Compliance Markings Electromagnetic Compatibility NoticesProduct Certification Markings Taiwan Declaration of Conformity Europe CE Declaration of ConformityKorean RRL Compliance Installation PrecautionsAustralia / New Zealand Prevent Power Supply Overload Installation RequirementsPlace Battery Marking Use Only for Intended ApplicationsIntel Server Board S845WD1-E Product Guide