Lenovo Troubleshooting Invalid RFID Serialization Information and Bad SVP Data Issues for Laptops

	Solving computer problems
Message	Solution
0177: Bad SVP data, stop	Checksum of the supervisor password in the EEPROM is not correct. The
POST task.	system board should be replaced. Have the computer serviced.
0182: Bad CRC2. Enter	Checksum of the CRC2 setting in the EEPROM is not correct. Go to BIOS
BIOS Setup and load	Setup Utility. Press F9 and then Enter to load the default setting. Press F10
Setup defaults.	and then Enter to restart the system.
0185: Bad startup	Checksum of the startup sequence setting in the EEPROM is not correct. Go
sequence settings. Enter	to BIOS Setup Utility. Press F9 and then Enter to load the default setting.
BIOS Setup and load	Press F10 and then Enter to restart the system.
Setup defaults.
0187: EAIA data access	The access to EEPROM has failed. Have the computer serviced.
error
0188: Invalid RFID	The EEPROM checksum is not correct (block # 0 and 1). The system board
Serialization Information	should be replaced, and the box serial number needs to be reinstalled. Have
Area.	the computer serviced.
0189: Invalid RFID	The EEPROM checksum is not correct (block # 4 and 5). The system board
configuration	should be replaced, and the UUID needs to be reinstalled. Have the
information area	computer serviced.
0190: Critical low-battery	The computer turned off because the battery is low. Connect the ac adapter
error	to the computer and charge the battery, or replace the battery with a fully
	charged one.
0191: System Security -	The system configuration change has failed. Confirm the operation and try
Invalid remote change	again. To clear the error, enter the BIOS Setup Utility.
requested.
0192: System Security -	The Security Chip has been replaced with a different one. Have the
Embedded Security	computer serviced.
hardware tamper
detected.
0199: System Security -	This message is displayed if you enter a wrong supervisor password more
Security password retry	than three times. Confirm the supervisor password and try again. To clear
count exceeded.	the error, enter the BIOS Setup Utility.
01C8: More than one	Remove a Modem Mini-PCI Card. Otherwise, press Esc to ignore the
modem devices are	warning message. If it does not solve this problem, have the computer
found. Remove one of	serviced.
them. Press <Esc> to
continue.
01C9: More than one	Your ThinkPad computer has a built-in Ethernet feature, and you cannot
Ethernet devices are	add another such feature by installing an Ethernet device. If this error
found. Remove one of	message is displayed, remove the Ethernet device that you installed.
them. Press <Esc> to	Otherwise press Esc to ignore the warning message. If this does not solve
continue.	the problem, have the computer serviced.

Chapter 2. Solving computer problems 13